ETC 120075

SURFACE MOUNT LEDs - 3x2 Green
1.5 max
2.0
1.7
1.2
1
3.0
1, Anode
1.6
1
•
•
High Intensity
•
•
•
Solid state reliability
Also available as a
3mm device
Wide viewing angle
Ideal for backlighting
120075 SERIES
2
2, Cathode
2
MLQ = 50
0.5
Chip
Dimensions in mm (Typical)
Tolerance +/- 0.2 UOS
Not to Scale
Cathode mark
Ordering Information & Typical Technical Characteristics (Ta = 25°C)
Mean Time Between Failure = 100,000 Hours. * Duty Cycle <=1/10, Pulse Width <= 10msec
PART NUMBER
COLOUR
TYP. FWD
VOLTAGE
Vf @ Iopr
MAX FWD
VOLTAGE
Vf @ Iopr
FORWARD
CURRENT
lopr
MAX REV
CURRENT
I r(Vr =5V)
LUMINOUS
INTENSITY
lv@lopr
CHROMATICITY
COORDINATES
VIEWING
ANGLE
2θ 1/2
STANDARD INTENSITY
OPTICAL / ELECTRICAL CHARACTERISTICS (Ta = 25 oC)
-
120075
Green
3.5
4.0
20
50
400
120
UNITS
Water Clear
V
V
mA
µA
mcd
x/y
deg
PART NUMBER
COLOUR
FORWARD
CURRENT
Iopr max
PEAK FWD
CURRENT
I fp
*
REVERSE
VOLTAGE
Vr max
POWER
DISSIPATION
P dmax
DOM
WAVELENGTH
Typ. λD
OPERATING
TEMP
T opr
STORAGE
TEMP
T stg
STANDARD INTENSITY
ABSOLUTE MAXIMUM- RATINGS (Ta = 25oC)
120075
Green
25
80
5
100
525
-20 to +80
-30 to +100
UNITS
Water Clear
mA
mA
Vdc
mW
nm
°C
°C
PRECAUTIONS FOR HANDLING ELECTROSTATIC SENSITIVE LEDs
Static Electricity and Surge
Static electricity and surge will damage the LED and a high standard of care must be taken during handling. It is recommended that a wristband, conductive mat or
anti-electrostatic glove is used when handling the LEDs. All devices, equipment (e.g. soldering iron points) and machinery must be properly grounded.
SAFETY PRECAUTIONS FOR HANDLING HIGH BRIGHTNESS LEDs
The light output of the Products may cause injuries to human eyes in circumstances where they are viewed directly with unshielded eyes for more than a few seconds.
Please refer to European Standard BSEN 100015-1 1992
for further information.
© Marl Optosource 2000
Datasheet Reference 19/98 Issue 02
Marl Optosource • Fax: +44 (0)1229 580012 •
email: [email protected]
•
website: www.optosource.com
• Telephone +44 (0)1229 582430