DOL Starters ■ Up to 7.5kW ■ IP65 enclosure ■ Start-Stop pushbuttons ■ Hand-Off-Auto selector ■ Wired to accept overload ■ Indicator ■ Anti-condensation heater P1M PRODUCT SPECIFICATION OR TO ORDER Options and ordering codes P1 Series P1 M20 x 1.5 conduit knoockouts M Start-stop pushbuttons T Reset Pushbuttons R Hand-Off-Auto and reset W M T COIL VOLTAGE 09 Standard coils 220-240V 50Hz 380-415V 50Hz 09 9 amps AC3 16 16 amps AC3 Specificications P1M_09 P1M_16 Contactor K2-09A10 K2-16A10 Overload U1216E U1216E Max. frequency of operation 15/hour Max. temperature 40˚C Ratings AC3 at 400V Enclosure protection Amps 9 16 kW 4 7.5 HP 6 ‘T’ x ‘R’ ‘W’ Coil 11 IP 65 IP 65 Inrush VA Hold VA Voltage Range 35 -– 45 7 – 10 0.85 – 1.1 Cable cross section Line Solid or stranded mm2 Flexible mm 0.75 – 2.5 0.5 – 2.5 Cables per clamp Motor 0.75 – 4 Flexible with multicore cable end mm2 2 Solid or stranded mm2 2 0.75 – 6 + 0.75 – 2.5 Flexible mm2 0.75 – 4 + 0.5 – 2.5 Flexible with multicore cable end mm2 0.5 – 2.5 + 0.5 – 1.5 Cables per clamp 1+1 P1M Selection and product pricing Starter Overload AC3 Rating at 400V Amps kW HP 9 16 9 16 9 16 4 7.5 4 7.5 4 7.5 6 11.5 6 11.5 6 11.5 Start-Stop P/B Start-Stop P/B Reset P/B Reset P/B H-O-A H-O-A Euro prices on request Starters are wired to accept overload. Overloads supplied as separate item. Specify coil voltage. Range Amps 0.12–0.18 0.18–0.27 0.27–0.4 0.4–0.6 0.6–0.9 0.8–1.2 1.2–1.8 1.8–2.7 2.7–4 4–6 6–9 8–11 10–14 13–18 17–23 23–30 PRODUCT SPECIFICATION OR TO ORDER Euro prices on request Accessories Description Normally open auxiliary – Max 2 Normally closed auxiliary – Max 2 Anti-condensation heater – 415V 1.5W Euro prices on request Description Lens cap Green indicator Red indicator Neutral terminal Euro prices on request Typical circuit diagrams Wiring 3 Phase Motors Single Phase Motors Control Circuit P1M T09 P1M T16 Dimensions (mm) P1M T09 P1M T16 P1M W09 P1M W16 P1M W09 P1M W16