Data Sheet 60056-H IR6216 (NOTE: For new designs, we recommend IR’s new products IPS521 and IPS521S) INTELLIGENT HIGH SIDE MOSFET POWER SWITCH Product summary Vcc(op) 5-50V Features • Current limit for short circuit protection • Over-temperature protection • Active output negative clamp • Reverse battery protection for logic circuit • Broken ground protection • Short to Vcc protection • Low noise charge pump • Sleep mode supply current • 4kV ESD protection on all leads • Logic ground isolated from power ground 200mΩ RDS(on) Ilim 10A Tj(sd) 170oC Eav 100mJ Applications • Lamp driver • Programmable logic General Description The IR6216 is a 5 terminal monolithic HIGH SIDE SWITCH with built in short circuit, over- temperature, ESD protections, inductive load turn off capability and diagnostic feedback. The on-chip protection circuit limits the average current during short circuit if the drain current exceeds 10A. The protection circuit latches off the high side switch if the junction temperature exceeds 170oC and latches on after the junction temperature falls by 10oC. The Vcc (drain) to out (source) voltage is actively clamped at 55V, improving its performance during turn off with inductive loads. The on-chip charge pump high side driver stage is floating and referenced to the source of the Power MOSFET. Thus the logic to power ground isolation can be as high as 50V. This allows operation with larger offset as well as controlling the switch during load energy recirculation or regeneration. A diagnostic pin is provided for status feedback of short circuit, over temperature and open load detection. Block Diagram controller Truth Table Condition Normal Normal Output Open Output Open Shorted Output In Out H H L L H H H L H Current-Limiting Dg H L H H L Linear Mode L Shorted Output Over-Temperature H Over-Temperature L L L L Available Packages Vcc 5 Lead SMD220 5 Lead TO-220 GND Powered by ICminer.com Electronic-Library Service CopyRight 2003 OUT L L L IR6216 Absolute Maximum Ratings Absolute maximum ratings indicate sustained limits beyond which damage to the device may occur. (TC = 25oC unless otherwise specified.) Symbol Vcc Parameter Supply voltage permanent reverse Logic to power ground offset Input voltage Input current Output voltage Output current Diagnostic output voltage Diagnostic output current Repetitive avalanche energy Electrostatic discharge (Human Body Model) Electrostatic discharge (Machine Model) Power dissipation Operating junction temperature range Storage temperature range Lead temperature (soldering, 10 seconds) Voffset Vin Iin Vout Iout Vdg Idg Eav ESD1 ESD2 PD TJop T Stg TL NOTES: (1) with 15kΩ resistors in input and diagnostic Min. Max. -0.3 -16 Vcc -50 -0.3 — Vcc -50 — -0.3 — — — — — -40 -40 — 50 — Vcc +0.3 30 10 Vcc +0.3 Units For 10 seconds, (1) V mA V A V mA mJ V V W self-limited 30 10 100 4000 1000 28 150 150 300 Test Conditions I = 2A (2) C = 100 pF,R = 1500Ω C = 200 pF, R = 0Ω Tcase= 25oC o C (2) maximum frequency depends on heatsink (rectangular waveform) Static Electrical Characteristics (TC= 25°C unless otherwise specified.) Symbol Parameter Vccop I ccoff Iccon I ccac Vih Vil Ilon I loff I oh Iol Vdgl I dgh RDS (on) Operating voltage range Sleep mode supply current Supply current (average) Supply current (AC RMS) High level input threshold voltage Low level input threshold voltage On-state input current Off-state input current Output leakage current Output leakage current Low level diagnostic output voltage Diagnostic output leakage current On-state resistance 2 Powered by ICminer.com Electronic-Library Service CopyRight 2003 Min. Typ. 5 — — — — 1 10 1 — 0 — 0 — — — 40 3 20 2 1.8 — — 20 — 0.3 — 150 200 Max. Units Test Conditions 35 — — — 2.5 — 70 30 — 10 — 10 200 — V µA mA µA Vcc=24V, Vin= 0V Vin = 5V Vin = 5V V µA V µA mΩ Vin = 3.5V Vin = 0.4V Vout = 6V Vout = 0V Idg = 1.6mA Vdg = 5V Iout = 1A Vcc = 5V, Iout = 1A ww.irf.com IR6216 Switching Electrical Characteristics (VCC = 14V, Resistive Load (RL) = 12Ω, TC= 25°C.) Symbol Parameter t on t off dv/dton dv/dt off Turn-on delay time to 90% Turn-off delay time to 10% Slew rate on Slew rate off Min. Typ. — — — — 50 60 3 5 Min. Typ. — — — 50 — 10 3.5 3.5 54 56 Min. Typ. — — — — 170 10 3.5 50 Max. Units Test Conditions — — — — µs V/µs Protection Characteristics Symbol Parameter Ilim Vsc Vslh Vcl1 Vcl2 Internal current limit Short circuit detection voltage Open load detection voltage Output negative clamp Output negative clamp Max. Units Test Conditions A — — — — 62 V Iout = 10mA Iout = 2A Thermal Characteristics Symbol Parameter T jsd T hys R thjc R thja Thermal shutdown temperature Thermal hysteresis Thermal resistance, junction to case Thermal resistance, junction to ambient Max. Units Test Conditions — — — — o C o C/W Lead Assignments 3 (Vcc) 3 (Vcc) 1 2 3 4 5 - Ground - In - Vcc - DG - Out 12345 12345 5 Lead - D2PAK (SMD220) 5 Lead - TO-220 IR6216 IR6216S Part Number www.irf.com Powered by ICminer.com Electronic-Library Service CopyRight 2003 3 IR6216 Case Outline 5 Lead - TO-220 IRGB 01-3042 01 Tape & Reel 5 Lead - D2PAK (SMD220) 01-3071 00 / 01-3072 00 4 Powered by ICminer.com Electronic-Library Service CopyRight 2003 ww.irf.com IR6216 Case Outline 5 Lead - SMD220 (D2PAK) 3 01-3066 00 WORLD HEADQUARTERS: 233 Kansas St., El Segundo, California 90245 Tel: (310) 322 3331 IR GREAT BRITAIN: Hurst Green, Oxted, Surrey RH8 9BB, UK Tel: ++ 44 1883 732020 IR JAPAN: K&H Bldg., 2F, 30-4 Nishi-Ikebukuro 3-Chome, Toshima-Ku, Tokyo, Japan 171-0021 Tel: 8133 983 0086 IR HONG KONG: Unit 308, #F, New East Ocean Centre, No. 9 Science Museum Road, Tsimshatsui East, Kowloon, Hong Kong Tel: (852) 2803-7380 http://www.irf.com/ Data and specifications subject to change without notice. 11/2/99 www.irf.com Powered by ICminer.com Electronic-Library Service CopyRight 2003 5