PA1153 1800 -2000 MHz. Low Noise Linear Power Amplifier Features (typical values) Low Noise ...................................................1.0 dB. High IP3 ..................................................... 45 dBm. High Gain ..................................................... 27 dB. Low Cost Electrical Specifications Parame te r Typical Performance Curves G a in v s . F r e q u e n c y (Referenced to 50 ohms) Typical Value M in. Value M ax. Value Units 1800 2000 MHz. 2 9 .5 29 2 8 .5 28 1800 Frequency Gain 2 8 .5 Gain Flatness ±0.3 Reverse Isolation 27.0 dB. ±0.5 40 2 6 .4 Noise Figure 1.0 IP3 +45.0 VSWR 1.5:1 2000 2 dB. 1 .5 1 dB. 25.0 1940 N F v s . F re q u e n c y 0 .5 1800 Pout @ 1dB. comp. 1870 1870 1940 2000 dBm. 1.3 +42.0 dB. P o u t v s . F re q u e n c y 28 dBm. 27 26 2.0:1 25 Supply Req'd +15/250 +15/300 1800 v./mA. IP3 measured with 2 tones @+15dBm. per tone spaced 1 MHz. apart Min and max values from 0 to 85 degrees C 1870 1940 2000 V S W R vs. Frequ ency In O ut 2 1 .5 Outline Drawings 1 1800 1870 1940 2000 IP 3 vs . F r e q u e n c y 50 48 46 44 1800 1870 1940 2000 F re q u e n c y in M H z . Maximum Ratings Storage Temperature ....... -40°C to +125°C DC Voltage .................................. +17 volts RF Input Power ........................... +15 dBm. Case Temperature ............................ +95°C Rev: 071701 Specifications subject to change without notice 100 Emlen Way Telford, Pa. 18969 Tel. (215) 723-6011 Fax. (215) 723-6015