Miniature Slides for High Frequency Series FS Distinctive Characteristics For high frequency (DC through 1GHz): Isolation 40dB minimum at 1GHz. Insertion loss 0.5dB maximum at 1GHz. Impedance 75 ohms Innovative alternative to relay products Actual Size with Tall Actuator Highly reliable, self-cleaning twin contact mechanism with gold plating Long total travel of .138” (3.5mm) for highly visible actuator position Distinct audible and tactile feedback during actuation Suited to high frequency applications (90MHz to 1GHz) such as CATV and communication equipment General Specifications Electrical Capacity (Resistive Load) Logic Level: RF Ratings Impedance: Insertion Loss: Isolation: Other Ratings Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Contact Timing: Total Travel: Environmental Data Operating Temp Range: Humidity: Vibration: Shock: Installation Soldering Time & Temp: Cleaning: 0.4VA maximum @ 28V AC/DC maximum (Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V) Note: Find additional explanation of operating range in Supplement section. 75 ohms 0.5dB maximum @ 1GHz 40dB minimum @ 1GHz 200 milliohms maximum 250 megohms minimum @ 500V DC 500V AC minimum for 1 minute minimum 1,000 operations minimum 1,000 operations minimum Nonshorting (break-before-make) .138” (3.5mm) –30°C through +85°C (–22°F through +185°F) 90 ~ 95% humidity for 240 hours @ 40°C (104°F) 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 5 minutes; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Wave Soldering: See Profile A in Supplement section. Manual Soldering: See Profile A in Supplement section. These devices are not process sealed. Hand clean locally using alcohol based solution. NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 03-07 Series FS Miniature Slides for High Frequency TYPICAL SWITCH ORDERING EXAMPLE FS 2 2 P A FREQUENCY BAND POLE 2 A A DPDT TERMINALS P DC through 1GHz ACTUATORS CIRCUIT 2 ON NONE Straight PC ON A Short (.291” or 7.4mm) B Tall (.488” or 12.4mm) DESCRIPTION FOR TYPICAL ORDERING EXAMPLE FS22AAP Short Actuator DPDT ON-NONE-ON Circuit Frequency Band DC through 1GHz Straight PC Terminals POLE & CIRCUIT Slide Position Pole Model DP FS22 Connected Terminals Left Center Right Left Center Right ON NONE ON 2-1 5-4 NA 2-3 5-6 Throw & Schematics Note: Terminal numbers are not actually on the switch. DPDT 2 1 (COM) 3 4 NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 5 6 03-07 Series FS Miniature Slides for High Frequency HIGH FREQUENCY PERFORMANCE RF Connection Options Option 2 1 5 2 6 3 Out In 4 1 5 2 6 3 Out In 4 1 5 2 6 3 Out In A T = Circuit Trace 90 Option 3 Direction of Actuation 4 Direction of Actuation Direction of Actuation Option 1 Out 2 A T = Terminator A = Amplifier or other device Isolation Insertion Loss >40dB @ 1GHz (higher value is better) <0.5dB @ 1GHz (lower value is better) Standing Wave Ration or Impedance Matching Isolation: Greater than 40dB @ 1GHz 0.6 80 0.5 70 0.4 dB 60 dB 0.3 50 0.2 40 0.1 30 10MHz 500MHz 1GHz 0 Standing Wave = ratio between highest voltage & lowest voltage (must always be more than 1) Insertion Loss: Less than 0.5dB @ 1GHz 1.6 VSWR (Voltage Standing Wave Ratio): 1:1 @ 1GHz 1.5 1.4 V S 1.3 W R 1.2 1.1 10MHz 500MHz 1 1GHz 10MHz 500MHz 1GHz Note: The data above reflects the conditions using the FS switch on a test PCB with two coaxial connectors. High frequency applications require external connection on the PCB. Contact factory for details. TYPICAL SWITCH DIMENSIONS Short & Tall Actuators (3.5) Travel .138 (7.4) .291 (3.5) Typ .138 (17.0) .669 (15.7) .618 Part No. (3.5) Travel .138 (1.75) Typ .069 (3.0) Sq .118 (7.4) .291 FS22ABP (12.4) .488 (0.3) .012 (9.6) .378 1 4 4 1 2 5 5 2 (0.8) Dia Typ 6 .031 (1.2) Dia Typ .047 (1.6) Dia Typ .063 3 6 3 (0.6) Typ .024 (0.3) Typ .012 (2.9) .114 (2.0) Typ .079 (1.75) Typ .069 (3.5) Typ .138 (7.85) Typ .309 (4.0) .157 Actuator in LEFT position. NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 03-07