Toggles Series FS Rockers General Specifications Pushbuttons For high frequency (DC through 1GHz): Isolation 40dB minimum at 1GHz. Insertion loss 0.5dB maximum at 1GHz. Impedance 75 ohms Programmable Illuminated PB Highly reliable, self-cleaning twin contact mechanism with gold plating Long total travel of .138” (3.5mm) for highly visible actuator position Distinct audible and tactile feedback during actuation Keylocks Suited to high frequency applications (90MHz to 1GHz) such as CATV and communication equipment Slides Rotaries Distinctive Characteristics Electrical Capacity (Resistive Load) H Logic Level: Tactiles Impedance: Insertion Loss: Isolation: Indicators Touch Tilt Other Ratings Accessories Actual Size with Tall Actuator Innovative alternative to relay products RF Ratings Supplement Miniature Slides for High Frequency Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Contact Timing: Total Travel: Environmental Data Operating Temp Range: Humidity: Vibration: Shock: Installation Soldering Time & Temp: Cleaning: H14 0.4VA maximum @ 28V AC/DC maximum (Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V) Note: Find additional explanation of operating range in Supplement section. 75 ohms 0.5dB maximum @ 1GHz 40dB minimum @ 1GHz 200 milliohms maximum 250 megohms minimum @ 500V DC 500V AC minimum for 1 minute minimum 1,000 operations minimum 1,000 operations minimum Nonshorting (break-before-make) .138” (3.5mm) –30°C through +85°C (–22°F through +185°F) 90 ~ 95% humidity for 240 hours @ 40°C (104°F) 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 5 minutes; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Wave Soldering: See Profile A in Supplement section. Manual Soldering: See Profile A in Supplement section. These devices are not process sealed. Hand clean locally using alcohol based solution. www.nkk.com Series FS Toggles Miniature Slides for High Frequency 2 2 A A P Pole A DPDT Terminals P DC through 1GHz Circuit ON Actuators NONE ON A Short (.291” or 7.4mm) B Tall (.488” or 12.4mm) Rotaries 2 Straight PC Keylocks 2 Frequency Band Programmable Illuminated PB Pushbuttons FS Rockers TYPICAL SWITCH ORDERING EXAMPLE H Tactiles FS22AAP Slides DESCRIPTION FOR TYPICAL ORDERING EXAMPLE Short Actuator DPDT ON-NONE-ON Circuit Tilt Frequency Band DC through 1GHz Touch Straight PC Terminals Model DP FS22 Left Center Right Left Center Right ON NONE ON 2-1 5-4 NA 2-3 5-6 www.nkk.com Throw & Schematics Note: Terminal numbers are not actually on the switch. DPDT 2 1 (COM) 3 4 5 6 H15 Accessories Pole Connected Terminals Supplement Slide Position Indicators POLE & CIRCUIT Series FS Toggles Miniature Slides for High Frequency HIGH FREQUENCY PERFORMANCE RF Connection Options 5 2 6 3 Out In 4 1 5 2 6 3 Out In Keylocks 1 5 2 6 3 Out In Out 2 A T = Terminator A = Amplifier or other device Isolation Insertion Loss >40dB @ 1GHz (higher value is better) <0.5dB @ 1GHz (lower value is better) Standing Wave Ration or Impedance Matching Isolation: Greater than 40dB @ 1GHz 80 H 4 A = Circuit Trace 90 Option 3 Direction of Actuation 1 T Rotaries Slides 4 0.6 Standing Wave = ratio between highest voltage & lowest voltage (must always be more than 1) Insertion Loss: Less than 0.5dB @ 1GHz 1.6 0.5 70 0.4 dB 60 dB 0.3 50 0.2 40 0.1 30 10MHz 500MHz 1GHz 0 VSWR (Voltage Standing Wave Ratio): 1:1 @ 1GHz 1.5 1.4 V S 1.3 W R 1.2 1.1 10MHz 500MHz 1 1GHz 10MHz 500MHz 1GHz Note: The data above reflects the conditions using the FS switch on a test PCB with two coaxial connectors. High frequency applications require external connection on the PCB. Contact factory for details. Tilt Tactiles Option 2 Direction of Actuation Programmable Illuminated PB Pushbuttons Direction of Actuation Rockers Option 1 TYPICAL SWITCH DIMENSIONS Touch Short & Tall Actuators Indicators (3.5) Travel .138 (7.4) .291 (3.5) Typ .138 Accessories (17.0) .669 (15.7) .618 Part No. (3.5) Travel .138 (1.75) Typ .069 (3.0) Sq .118 Supplement (7.4) .291 FS22ABP H16 (12.4) .488 (0.3) .012 (9.6) .378 4 4 1 5 5 2 (0.8) Dia Typ 6 .031 (1.2) Dia Typ .047 (1.6) Dia Typ .063 3 6 3 (0.6) Typ .024 (0.3) Typ .012 (2.9) .114 Actuator in LEFT position. www.nkk.com 1 2 (4.0) .157 (2.0) Typ .079 (1.75) Typ .069 (3.5) Typ .138 (7.85) Typ .309