RoHS Power Chip Low Profile Inductors Dimensions: PCLP05 Inches (mm) XXX DCR Max. (Ω) Isat (A) Irms (A) 100 0.08 2.1 3.6 20 100 0.10 1.9 2.8 2.2 20 100 0.12 1.6 2.4 3.3 20 100 0.16 1.3 2.0 Allied Part Number Inductance (µh) Tolerance (%) PCLP05-1R2M-RC 1.2 20 PCLP05-1R5M-RC 1.5 PCLP05-2R2M-RC PCLP05-3R3M-RC Test Freq. KHz, 0.1V Features • • • • • High Energy Storage SMD low cost design Low profile, 1mm nominal Designed for very low resistance Small size and high performance Excellent for use in step up and step down coverters • DC-DC conversion Electrical PCLP05-4R7M-RC 4.7 20 100 0.20 1.1 1.7 PCLP05-6R8M-RC 6.8 20 100 0.32 0.9 1.2 PCLP05-100M-RC 10 20 100 0.41 0.8 1.1 PCLP05-150M-RC 15 20 100 0.55 .65 0.9 PCLP05-220M-RC 22 20 100 0.85 0.5 .83 Inductance Range: 1.2µh to 330µh Tolerance: 20% over entire range Also available in tighter tolerances Test Frequency: (L/Q) as specified Operating Temp: -40ºC ~ +85ºC Isat: Current at which Inductance drops 10% of original value Irms: ∆ T= 40ºC rise typical at Irms. Resistance to Soldering Heat PCLP05-330M-RC 33 20 100 1.30 0.4 .62 PCLP05-470M-RC 47 20 100 1.80 .35 .52 PCLP05-680M-RC 68 20 100 2.50 .30 .35 PCLP05-101M-RC 100 20 100 3.50 .25 .27 PCLP05-151M-RC 150 20 100 5.00 .18 .24 PCLP05-221M-RC 220 20 100 7.00 .16 .23 PCLP05-331M-RC 330 20 100 15.0 .13 .13 Test Method: Reflow solder the devise onto PCB using 96.5 Sn/Ag3.0/Cu0.5 Solder paste. The solder process shall be 230ºC for 20 ± 2 sec. and 260ºC for 5 ± 2 seconds. Inductance shall remain within 10% of inital value. Test Equipment (L & Q): HP4192A / HP4285A (DCR): Chen Hwa 502BC (IDC): HP4284A with HP42841A or CH1061 with CH301A Physical All specifications subject to change without notice. Packaging: 3500 pieces per 13 inch reel. Marking: EIA Inductance Code. 714-665-1140 ALLIED COMPONENTS INTERNATIONAL REVISED 12/11/08 www.alliedcomponents.com