Data Sheet No. PD10044C Series PVT322A Microelectronic Power IC ® HEXFET Power MOSFET Photovoltaic Relay Dual Pole, Normally Open 0-250V, 170mA AC/DC General Description The PVT322A Series Photovoltaic Relay is a dual-pole, normally open solid-state relay that can replace electromechanical relays in many applications. It utilizes International Rectifier’s HEXFET power MOSFET as the output switch, driven by an integrated circuit photovoltaic generator of novel construction. The output switch is controlled by radiation from a GaAlAs light emitting diode (LED) which is optically isolated from the photovoltaic generator. Features § § § § § HEXFET Power MOSFET output Bounce-free operation 4,000 VRMS I/O isolation Linear AC/DC operation Solid-State Reliability Series PVT322A Relays are packaged in an 8-pin, molded DIP package with either through-hole or surface mount (gull-wing) terminals. It is available in standard plastic shipping tubes or on tape-andreel. Please refer to Part Identification information opposite. Applications § On/Off Hook switch § Tip and Ring Line switching Part Identification § General switching PVT322A through-hole PVT322AS SMT PVT322AS-T SMT, T&R (HEXFET is the registered trademark for International Rectifier Power MOSFETs) Series PVT322A Electrical Specifications (-40°C ≤ TA ≤ +85°C unless otherwise specified) INPUT CHARACTERISTICS Limits Units Minimum Control Current (See figure1) Maximum Control Current for Off-State Resistance @TA=+25°C Control Current Range (Caution: current limit input LED, see figure 5) 2.0 0.4 2.0 to 25 mA mA mA 7.0 V Maximum Reverse Voltage OUTPUT CHARACTERISTICS Limits Units Operating Voltage Range Maximum Load Current @ TA=+40°C 5mA Control (See figure 1) (single and dual channel operation) Maximum Peak Load Current (10ms maximum duration) (single and dual channel operation) Maximum On-State Resistance @TA=+25°C For 50mA Pulsed load, 5mA Control (see figure 3) Maximum Off-State Leakage @T A=+25°C, ±250V (see figure 4) Maximum Turn-On Time @T A=+25°C (see figure 6) For 50mA, 100 VDC load, 5mA Control Maximum Turn-Off Time @T A=+25°C (see figure 6) For 50mA, 100 VDC load, 5mA Control Maximum Output Capacitance @ 50VDC 0 to ±250 V(DC or AC peak) 170 mA 500 mA 8 1.0 3.0 Ω µA ms 0.5 ms 50 pF GENERAL CHARACTERISTICS Limits Units Minimum Dielectric Strength, Input-Output Minimum Dielectric Strength, Pole-to-Pole 4000 1000 VRMS VDC 1012 1.0 +260 -40 to +85 -40 to +100 Ω pF Minimum Insulation Resistance, Input-Output, @TA=+25°C, 50%RH, 100VDC Maximum Capacitance, Input-Output Maximum Pin Soldering Temperature (10 seconds maximum) Ambient Temperature Range: Operating Storage °C Connection Diagram 2 www.irf.com Series PVT322A 200 25 0 20 0 ILED = 5 mA 15 0 150 10 0 50 100 -3 .0 -2 .5 -2 .0 -1 .5 -1 .0 -0 .5 0 .5 1 .0 1 .5 2 .0 2 .5 3.0 -5 0 2 mA 50 -1 00 -1 50 0 0 20 40 60 80 -2 00 100 -2 50 Figure 2. Linearity Characteristics Figure 3. Typical Normalized On-Resistance Figure 4. Typical Normalized Off-State Leakage LED Current (mA) Figure 1. Typical Current Derating Curve Delay Time (milliseconds) Figure 5. Input Characteristics (Current Controlled) www.irf.com Figure 6. Typical Delay Times 3 Series PVT322A Figure 7. Delay Time Definitions Figure 8. Typical Output Capacitance Case Outline 01-2004 03 4 www.irf.com Series PVT322A Case Outline 01-2005 03 IR WORLD HEADQUARTERS: 233 Kansas St., El Segundo, California 90245 Tel: (310) 252-7105 IR EUROPEAN REGIONAL CENTRE: 439/445 Godstone Rd., Whyteleafe, Surrey CR3 0BL, United Kingdom Tel: ++ 44 (0) 20 8645 8000 IR JAPAN: K&H Bldg., 2F, 30-4 Nishi-Ikebukuro 3-Chome, Toshima-Ku, Tokyo, Japan 171-0021 Tel: 8133 983 0086 IR HONG KONG: Unit 308, #F, New East Ocean Centre, No. 9 Science Museum Road, Tsimshatsui East, Kowloon Hong Kong Tel: (852) 2803-7380 Data and specifications subject to change without notice. 8/1/2000 www.irf.com 5