REL185 1 8 5 Wa t t O p e n F rame Switching Power Supply with PFC series 185 Watts Output Power Universal 85-265VAC Input 1, 2, 3, and 4 Outputs Active Power Factor Correction 2.5VDC to 48VDC Outputs 7” x 4.25” x 1.31” Model Number Output #1 Output #2 Output #3 Output #4 Medical Versions Available Contact Factory SINGLE OUTPUT REL185-1001 REL185-1002 REL185-1003 REL185-1004 REL185-1005 REL185-1006 REL185-1007 REL185-1008 2.5V/37A 3.3V/37A 5V/37A 12V/15A 15V/12A 24V/7.7A 28V/6.6A 48V/3.8A DUAL OUTPUT REL185-2001 REL185-2002 REL185-2003 REL185-2004 REL185-2005 3.3V/20A 5V/20A 5V/20A 12V/10A 15V/8A 5V/10A 12V/8A 24V/4A -12V6A -15V/5A TRIPLE OUTPUT REL185-3001 REL185-3002 5V/20A 5V/20A 12V/5A 15V/4A QUAD OUTPUT REL185-4001 REL185-4002 REL185-4003 REL185-4004 REL185-4005 REL185-4006 REL185-4007 3.3V/20A 5V/20A 5V/20A 5V/20A 5V/20A 5V/20A 5V/20A 5V/10A 3.3V/10A 3.3V/10A -5V/10A -5V/10A 24V/3A 24V/3A -12V/3A -15V/3A 12V/2A 12V/2A 15V/2A 12V/2A 15V/2A 12V/2A 15V/2A Order On-Line! WWW.ASTRODYNE.COM astrodyne.com -12V/2A -12V/2A -15V/2A -12V/2A -15V/2A -12V/2A -15V/2A 300 Myles Standish Blvd., Taunton, MA 02780 Ph: 1-800-823-8082 Fax: 508-823-8181 REL185 1 8 5 Wa t t O p e n F rame Switching Power Supply with PFC INPUT SPECIFICATIONS Input Voltage, Full Range: Active PFC Input Frequency Inrush Current Leakage Current ENVIRONMENTAL SPECIFICATIONS 85-264 VAC >0.95@115VAC 47-63Hz. 30A @ 115VAC, typ 4 40A @ 230VAC, typ 4 <300uA @ 240VAC OUTPUT SPECIFICATIONS Output Power Minimum Load Requirement Max Current (A, Peak) Initial Accuracy Voltage Adjust Load Regulation Cross Regulation Line Regulation Temperature Coefficient Ripple/Noise Overvoltage Protection Remote Sense (Singles Only) Hold Up/Start Up Times Short Circuit Protection Current Limit Safety EMC 0 to +60 °C 4 10-95%, Description 4 -40 to +85 °C 4 100KHrs MIL-Std 217F To MIL-Std 810E Oper. Temperature Relative Humidity Storage Temperature MTBF Shock & Vibration PHYSICAL SPECIFICATIONS 135W, Conv/185W Forced Air 10% See Model Selection Chart 7 +/-1%, typ ± 5%, typ ± 1%, typ +/-5% ± 0.5%, typ ± 0.02%/°C 100mV Pk-Pk, typ 110-150%, Type 2 & 3 250mV compensation 16mS/5Sec, typ Continuous 4 110-160% typ, Auto Recovery GENERAL SPECIFICATIONS Input-Output Isolation Output-Ground Isolation Input-Ground Isolation Efficiency (@ Full Load) series Dimensions Material Flammability Construction Weight 7”x4.26”x1.31” to UL94V-0 Open Frame 1.7lb SPECIFICATION NOTES 1) All specifications typical @ 25°C, Nominal Line & Load, unless otherwise noted. 2) O/P noise measured directly at pins/terminals with 0.1uFbypass, pk-pk @ 20MHz bandwidth. 3) Ripple and Noise dependant upon output voltage as specified per particular model. 4) These are stress ratings. Exposure of the devices to any of these conditions may adversely affect long term reliability. Proper operation under conditions other than the standard operating conditions is neither warranteed or implied. 5) Isolation for up to 1 minute duration. 6) No termination necessary with control pin to maintain constant “ON” operation (if applicable to this model) 7) Max load (peak) specified for 10mS max, 20% duty cycle, minimum load on all outputs 3000VAC 5 500VAC 1500VAC 82%, typ (or See Chart/Curve) UL60950/EN60950 Approved EN55022/B, EN61000-3-2,3/A EN61000--4-2,3,4,5,6,8,11/Cr A All specifications are typical at nominal input, full load, and 25DegC unless otherwise noted A Blue Number means see respective Specification WWW.ASTRODYNE.COM Astrodyne products are not authorized or warranteed for use as critical components in life support systems, equipment used in hazardous environments, nuclear controls systems, or other mission-critical applications. 300 Myles Standish Blvd., Taunton, MA 02780 Ph: 1-800-823-8082 Fax: 508-823-8181 REL185 1 8 5 Wa t t O p e n F rame Switching Power Supply with PFC MECHANICAL DIMENSIONS series RECOMMENDED AIR FLOW DIRECTION OPEN FRAME 1 – Optimum 3 2 – Good 3 – Good 4 - Fair .128 DIA MTG HOLE (4 PLACES) P2 2 (+) (-) OUTPUT 1 OUTPUT 1 P3 1 2 3 4 5 6 7 8 (+) (+) (-) (-) (-) (+) (+) (-) OUTPUT 1 SENSE SENSE OUTPUT 1 P.F. RTN P.F.SIG REMOT SIG REMOTE RTN P2-2 (-) 4 2 P2-1 (+) 1 AC INPUT P3 L P1 N GND THERMAL PERFORMANCE FORCED AIR COOLING CONVECTION COOLING V1 ADJUST SINGLE OUTPUT MODEL 1 7.00 (177.8) 6.70 (170.2) .15 (3.81) 3.95 (100.3) P2 4.25 (107.9) 1 AC INPUT L 2 1 P2 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 (+) (+) (+) (+) (-) (-) (-) (-) (+) (+) (-) (-) (+) (-) (+) (-) P3 P1 6 N 5 V1 ADJUST GND P3 1 2 3 4 5 6 7 8 MULTIPLE OUTPUT MODEL (+) (+) (-) (-) (-) (+) (+) (-) CONVECTION COOLING WITH CHASIS / COVER OUTPUT 1 OUTPUT 1 OUTPUT 1 OUTPUT 1 OUTPUT 1 OUTPUT 1 OUTPUT 1 OUTPUT 1 OUTPUT 2 OUTPUT 2 OUTPUT 2 OUTPUT 2 OUTPUT 3 OUTPUT 3 OUTPUT 4 OUTPUT 4 OUTPUT 1 SENSE SENSE OUTPUT 1 P.F. RTN P.F.SIG REMOTE SIG REMOTE RTN CONNECTOR SPECIFICATIONS P1 AC Input .156 friction lock header mates with Molex 09-50-3031 crimp terminal 5.20 (132.1) .56 (14.2) housing with Molex 2478 crimp terminal 1.31 (33.3) 1.50 (38.1) P2 DC Output (Single) 6-32 screw down terminal accepts #6 ring tongue terminal P2 DC Output (Multiple) CHASSIS & COVER .156 friction lock header mates with Molex 09-50-3181 crimp terminal housing with Molex 2478 crimp terminal 6.70 (170.2) 4-40 MTG HOLE (2 PLACES) .76 (19.3) G Ground .187 quick disconnect terminal 1.74 (44.2) P3 Option Sense (Single) .100 breakaway header mates with Molex 50-57-9008 crimp terminal 7.23 (183.6) 3 housing with Molex 71851crimp terminal 6.70 (170.2) P3 Option Sense (Multiple) .100 breakaway header mates with Molex 22-55-2081 crimp terminal 4.36 (110.7) housing with Molex 71851 crimp terminal 4 2 3.95 (100.3) 4-40 MTG HOLE (4 PLACES-BASE) 1 ALL DIMENSIONS IN INCHES (MM) WWW.ASTRODYNE.COM 300 Myles Standish Blvd., Taunton, MA 02780 Ph: 1-800-823-8082 Fax: 508-823-8181