STMICROELECTRONICS STB6100_09

STB6100
8PSK/QPSK direct conversion tuner IC
Features
■
Direct conversion
■
Input range 950 to 2150 MHz
■
Low pass filter bandwidth 5 to 36 MHz
■
Fully integrated LO and PLL
■
Differential I/Q outputs
■
Buffered XO output to clock other devices
■
Low external component count
■
Low power consumption
■
2-wire I²C serial interface
■
Low-cost integrated ZIF tuner for DVB-S2 and
DIRECTV®, VSAT and internet through
satellite applications
■
■
■
QPSK/8PSK/16APSK and 32APSK support
Simple interface to ST’s satellite demodulator
devices
Low phase noise, excellent linearity and high
LO harmonics rejection
GND
GND
VTUNE
VCCSCV
SYN_BYP
LD
CP
CP_BYP
GND
Functional block diagram
VCO_BYP
Figure 1.
3
2
3
1
3
0
2
9
2
8
2
7
2
6
2
5
OP
AMP
1
Delta
Sigma
2
/2 or /1
GND
3
GND
4
VCCMIX
5
LD
CP
/(Ni+Nf)
24
XTAL
23
XOOUT
22
XTALB
21
XO_BYP
20
IOUT
19
IOUTB
18
QOUTB
17
QOUT
PDF
Divide
2/4
DC Offset
Cancellation
o
0
90o
■
VFQFPN2 5x5x1.0 32 pitch package
VCCRF
6
AGC
Control
7
DC Offset
Cancellation
BW
Table 1.
1
3
AS
1
5
1
6
Device summary
Order code
April 2009
1
4
VCCBB
1
2
CLK
1
1
TSTA
VCCBIAS
9
1
0
AGC
8
VREG3
RFIN
Packing
STB6100
Standard tray version
STB6100T
Tape and real
Doc ID 10839 Rev 2
BB
Gain
2-Wire Bus
DATA
GND
1/5
www.st.com
5
Description
1
STB6100
Description
The STB6100 ASIC is a highly integrated, low-cost direct conversion (zero IF) tuner IC for
DVB-S2 broadcast satellite applications.
This device includes an LNA, down-converting mixers, baseband low-pass filters, gain
control, on-chip VCO and a low noise PLL. Its wide gain control range is well suited for low
symbol rate applications.
The STB6100 is controlled by a simple two-wire interface and has been designed to
minimize the external bill of materials to reduce manufacturing costs and to simplify the
board layout. The reduced component count ensures greater system reliability leading to
increase consumer satisfaction.
The DVB-S2 standard increases the capacity of satellite broadcasts by as much as 30%, so
enabling the effective deployment of high data rate applications such as high definition TV
and broadband internet. Packaged in VFQFPN2 5x5x1.0 32 pitch 0.50 package, it is ideal
for low cost DBS design.
2/5
Doc ID 10839 Rev 2
ECOPACK®
STB6100
2
ECOPACK®
In order to meet environmental requirements, ST offers these devices in different grades of
ECOPACK® packages, depending on their level of environmental compliance. ECOPACK®
specifications, grade definitions and product status are available at: www.st.com.
ECOPACK® is an ST trademark.
Doc ID 10839 Rev 2
3/5
Revision history
3
STB6100
Revision history
Table 2.
4/5
Document revision history
Date
Revision
Changes
05-Sept-2004
1
Initial release.
21-Apr-2009
2
Supported features updated.
Doc ID 10839 Rev 2
STB6100
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2009 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
Doc ID 10839 Rev 2
5/5