STEVAL-CCA001V1 Mono class audio amplifier based on TS4962MEIJT in flip chip Data Brief Features ■ Operating from Vcc = 2.4 V to 5.5 V ■ Ultra low power consumption in standby mode (10 nA) ■ 63 dB PSRR @ 217 Hz in grounded mode (average = 2 V/V) ■ Low pop and click ■ Fast startup time (5 ms) ■ Module gain set at 2 V/V ■ Thermal and short circuit protection STEVAL-CCA001V1 Description This board is a general-purpose developmant platform for all applications based on the TS4962M mono class D audio amplifier. The TS4962M is a monolithic fully-differential input/ output class D power amplifier. It also includes a common-mode feedback loop that controls the output bias value to average it at VCC/2 for any DC common mode input voltage. This allows the device to always have a maximum output voltage swing, and consequently maximizes the output power. Moreover, as the load is connected differentially compared to a single-ended topology, the output is four times higher for the same power supply voltage. October 2007 Rev 1 For further information contact your local STMicroelectronics sales office. 1/4 www.st.com 4 Board schematic 1 STEVAL-CCA001V1 Board schematic Figure 1. Scheme Vcc Vcc Cn1 + J1 + 1 2 3 Cn2 GND GND C1 2.2uF/10V GND Vcc Cn4 + J2 3 8 U1 Vcc C2 300k 4 Stdby R1 Internal Bias Out+ 150k 6 Cn3 Positive Input Negative input 100nF 150k 100nF R2 C3 150k 5 1 Output - InIn+ + PWM Cn6 Positive Output H Bridge Negative Output 10 150k Out- Oscillator TS4962 Flip-Chip to DIP Adapter GND Cn5 + J3 2 GND 2/4 3 STEVAL-CCA001V1 2 Revision history Revision history Table 1. Document revision history Date Revision 19-Oct-2007 1 Changes Initial release 3/4 STEVAL-CCA001V1 Please Read Carefully: Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. All ST products are sold pursuant to ST’s terms and conditions of sale. Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein. UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK. Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any liability of ST. ST and the ST logo are trademarks or registered trademarks of ST in various countries. Information in this document supersedes and replaces all information previously supplied. The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners. © 2007 STMicroelectronics - All rights reserved STMicroelectronics group of companies Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America www.st.com 4/4