TOCP172−□□B OPTICAL FIBER WITH FIBER OPTIC CONNECTORS TOCP172− B OPTICAL FIBER WITH FIBER OPTIC CONNECTORS FOR DIGITAL AUDIO USE Unit: mm l Fiber optic connectors conform to the JEITA proposed standerds RC−5720. l Simplex type l APF (970 / 1000µm) 1. Maximum Ratings (Ta = 25°C) Characteristics Ratings Unit Storage Temperature −40 to 70 °C Operating Temperature −20 to 70 °C 19.6 N Tension Between Fiber and Connector Optical Fiber Bending Radius 49 N Min 25 mm 2. Optical Characteristics (Ta = 25°C) Characteristics Transmission Loss Test Condition λp = 660nm, Measured by fiber length 50m 1 Min Typ. Max Unit ― ― 400 dB / km 2001-07-26 TOCP172−□□B 3. Precautions for Operation (1) (2) (3) (4) (5) (6) (7) The maximum ratings are the limit values which should not be exceeded when using this product. All of these values must be within the defined range. If the maximum ratings, are exceeded the deviced characteristics may not be recoverable and, in extreme cases, permanent damage to the product may result. Care should be taken not to exceed the maximum ratings when using this product. Care should be taken not to drop heavy objects onto the optical fiber cables. When connecting or disconnecting the optical fiber with fiber optic connector, be sure to hold the fiber optic connector. Do not hold the optical fiber cable when connecting or disconnecting. When inserting the fiber optic connector into the fiber optic transmitting/receiving module, be sure to follow the correct fitting alignment. Keep the end face of the optical fiber with fiber optic connector clean. If contaminated, wipe it gently with tissue paper. When bending the optical fiber cable to install it, note that the recommended bending radius is six to ten times longer than the minimum bending radius. −□□ indicates the length and the unit of length of the optical fiber of the optical fiber with fiber optic connector or optical fiber products. The length of the optical fiber is the distance from one end of fiber optic connector to the other end. The minimum fiber length is 0.2m. EX. TOCP172−1MB Unit of length C: cm M: m Length 2 2001-07-26 TOCP172−□□B RESTRICTIONS ON PRODUCT USE 000707EAA · TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability Handbook” etc.. · The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in this document shall be made at the customer’s own risk. · The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA CORPORATION for any infringements of intellectual property or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any intellectual property or other rights of TOSHIBA CORPORATION or others. · The information contained herein is subject to change without notice. 3 2001-07-26