Oscilent Corporation RF SAW Filter | 801-RF2642.5M-A Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 801-RF2642.5M-A 2.5 x 2.0 SMD DBM Mar. 14, 2007 . TYPE : DBM, RF SAW Filter PART NUMBER : 801-RF2642.5M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Attenuation: Condition Minimum Typical Maximum Units - - 2642.5 - MHz 2630.0~ 2655.0 MHz - 3.0 3.5 dB DC~ 2400.0 MHz 20 30 - 2400.0~ 2500.0 MHz 20 28 - 2750.0~ 3500.0MHz 18 25 - dB 3500.0~ 6000.0 MHz 15 22 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm VSWR 2630.0~ 2655.0 MHz - 1.7 2.5 - Amplitude Ripple 2630.0~ 2655.0 MHz - 0.8 1.5 dBp-p Maximum DC Voltage - - - 0.2 V Maximum Input Power - - - 0 dBm Operating Temperature - -30 - +80 ºC * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Out D Ground Oscilent Corporation RF SAW Filter | 801-RF2642.5M-A Page 2 of 2 Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 801-RF2642.5M-A