Oscilent Corporation RF SAW Filter | 803-RF413.7M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 803-RF413.7M-A 3.8 x 3.8 SMD CDMA450 Tx Jan. 01, 2007 . TYPE : CDMA450 (D-Band), RF-Tx SAW Filter PART NUMBER : 803-RF413.7M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Condition Minimum Typical Maximum Units - - 413.7 - MHz 411.6 ~ 415.9 MHz - 1.8 2.8 dB 0.3 ~ 400.0 MHz 25 27 - 421.6 ~ 425.9 MHz 30 50 - 425.9 ~ 1700.0MHz 23 27 - 1700.0~ 2000.0 MHz 18 21 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm 411.6 ~ 415.9 MHz - 1.5 2.0 - Maximum Input Power - - - 30 dBm Operating Temperature - -30 - +80 ºC Stop Band Attenuation: VSWR dB * No Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Ground D Ground E Out F Ground Oscilent Corporation RF SAW Filter | 803-RF413.7M-A Source/ Load Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Page 2 of 3 Oscilent Corporation RF SAW Filter | 803-RF413.7M-A Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 803-RF413.7M-A