Oscilent Corporation RF SAW Filter | 805-RF465.0M-D Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 805-RF465.0M-D 5.0 x 5.0 SMD CDMA450 Rx Jan. 01, 2007 . TYPE : CDMA450, RF SAW Filter, Rx PART NUMBER : 805-RF465.0M-D .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Stop Band Attenuation: Condition Minimum Typical Maximum Units - - 465.0 - MHz 462.5 ~ 467.5 MHz - 2.6 4.3 dB 0.3 ~ 452.5 MHz 40 45 - 452.5 ~ 457.5 MHz 35 45 - 485.0 ~ 507.5 MHz 40 50 - 507.5 ~ 1200.0 MHz 30 44 - dB 1200.0~ 1700.0 MHz 20 28 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm 462.5 ~ 467.5 MHz - 1.4 2.0 - VSWR Maximum Input Power - - - 27 dBm Operating Temperature - -30 - +80 ºC * No Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Ground D Ground E Ground F Out G Ground H Ground Oscilent Corporation RF SAW Filter | 805-RF465.0M-D FREQUENCY RESPONSE VSWR SMITH CHART Page 2 of 3 Oscilent Corporation RF SAW Filter | 805-RF465.0M-D Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 805-RF465.0M-D