Oscilent Corporation RF SAW Filter | 862-RF427.75M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 862-RF427.75M-A 3.0 x 3.0 SMD CDMA450(E-Band) Jan. 01, 2007 . TYPE : CDMA450(E-Band), Balanced RF-Rx SAW Filter PART NUMBER : 862-RF427.75M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Stop Band Attenuation: Condition Minimum Typical Maximum Units - - 427.75 - MHz 425.5~ 430.0 MHz - 2.3 4.5 dB 0.3~ 415.5 MHz 40 50 - 415.5~ 420.0 MHz 35 48 - 450.0~ 600.0MHz 35 40 - 600~ 1200.0 MHz 40 50 - dB 1200~ 2000.0 MHz 30 45 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (balanced ended)* - - 100 - ohm 425.5~ 430.0 MHz - 1.7 2.4 - VSWR Maximum Input Power - - - 27 dBm Operating Temperature - -30 - +80 ºC * No Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Ground D Ground E Out F Ground G Out H Ground Oscilent Corporation RF SAW Filter | 862-RF427.75M-A Load Impedance = 100 ohms Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR Page 2 of 3 Oscilent Corporation RF SAW Filter | 862-RF427.75M-A Page 3 of 3 SMITH CHART Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 862-RF427.75M-A