RF SAW Filter Part Number Package Application Last Modified 802-RF1765.0M-D 3.0 x 3.0 SMD K-PCS Mar. 2, 2007 . TYPE : K-PCS, RF-Tx SAW Filter PART NUMBER : 802-RF1765.0M-D .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 1765.0 - MHz Maximum Insertion Loss 1750.0~ 1780.0 MHz - 2.4 3.2 dB Attenuation: 1350.0~ 1380.0 MHz 35 40 - 1660.0~ 1690.0 MHz 35 40 - 1840.0~ 1870.0MHz 40 45 - Center Frequency (Fo) dB 2150.0~ 2180.0 MHz 40 50 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm VSWR 1750.0~ 1780.0 MHz - 1.6 2.0 - Amplitude Ripple dBp-p 1750.0~ 1780.0 MHz - 1.0 1.5 Maximum DC Voltage - - - 7.5 V Maximum Input Power - - - 15 dBm Operating Temperature - -30 - +85 ºC * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF1765.0M-D