RF SAW Filter Part Number Package Application Last Modified 862-RF462.5M-D 3.0 x 3.0 SMD CDMA450(C-Band) Mar. 2 2007 . TYPE : CDMA450, Balanced RF-Rx SAW Filter (C-Band) PART NUMBER : 862-RF462.5M-D .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Stop Band Attenuation: Condition Minimum Typical Maximum Units - - 462.5 - MHz 460.0~ 464.8 MHz - 2.7 4.5 dB 0.3~ 450.0 MHz 40 50 - 450.0~ 455.0 MHz 35 47 - 485.0~ 505.0MHz 40 48 - 505.0~ 1200.0 MHz 40 55 - dB 1200~ 2000.0 MHz 35 50 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (balanced ended)* - - 100 - ohm 460.0~ 464.8 MHz - 1.7 2.4 - VSWR Maximum Input Power - - - 27 dBm Operating Temperature - -30 - +80 ºC * No Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Ground D Ground E Out F Ground G Out H Ground Load Impedance = 100 ohms Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 862-RF462.5M-D