RF SAW Filter Part Number Package Application Last Modified 862-RF465.0M-F 3.0 x 3.0 SMD CDMA450 Mar. 2 2007 . TYPE : CDMA450, Balanced RF-Rx SAW Filter PART NUMBER : 862-RF465.0M-F .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Stop Band Attenuation: Condition Minimum Typical Maximum Units - - 465.0 - MHz 462.5~ 467.5 MHz - 2.4 4.5 dB 0.3~ 452.5 MHz 40 50 - 452.5~ 457.5 MHz 35 48 - 485.0~ 507.5MHz 40 43 - 507.5~ 1200.0 MHz 30 50 - dB 1200.0~ 1700.0 MHz 20 35 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (balanced ended)* - - 100 - ohm 462.5~ 467.5 MHz - 1.7 2.1 - VSWR Maximum Input Power - - - 27 dBm Operating Temperature - -30 - +80 ºC * No Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Ground D Ground E Out F Ground G Out H Ground Load Impedance = 100 ohms Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 862-RF465.0M-F