Oscilent Corporation RF SAW Filter | 802-RF1880.0M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 802-RF1880.0M-A 3.0 x 3.0 SMD US-PCS Mar. 2, 2007 . TYPE : US-PCS, RF-Tx SAW Filter PART NUMBER : 802-RF1880.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Attenuation: Source Impedence (single ended)* Condition Minimum Typical Maximum Units - - 1880.0 - MHz 1850.0~ 1910.0 MHz - 3.0 4.0 dB D.C.~ 1600.0 MHz 20 32 - 1600.0~ 1721.0 MHz 25 32 - 1721.0~ 1800.0MHz 20 37 - 1930.0~ 1990.0 MHz 7 19 - 2000.0~ 2040.0 MHz 25 37 - 2040.0~ 2480.0 MHz 31 38 - 3700.0~ 3820.0 MHz 25 28 - - - 50 - ohm ohm dB - - 50 - VSWR 1850.0~ 1910.0 MHz - 1.8 2.2 - Amplitude Ripple 1850.0~ 1910.0 MHz - 1.7 2.5 dBp-p Maximum DC Voltage - - - 5 V Maximum Input Power - - - 10 dBm Operating Temperature - -30 - +85 ºC Load Impendance (single ended)* * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground Oscilent Corporation RF SAW Filter | 802-RF1880.0M-A Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Page 2 of 3 Oscilent Corporation RF SAW Filter | 802-RF1880.0M-A Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF1880.0M-A