Oscilent Corporation IF SAW Filter | 813-SL125.0M-30 Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 813-SL125.0M-30 13.3 x 6.5 SMD Low-Loss 125MHz Jan 01, 2007 TYPE : Low-Loss 125MHz IF SAW Filter PART NUMBER : 813-SL125.0M-30 OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency (Fo) - 125.0 - MHz Insertion Loss at Fo - 12.0 14.0 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Temperature Coefficient - -94 - ppm/C - 0.65 1.0 dBp-p 1dB Bandwidth 29.0 30.5 - MHz 3dB Bandwidth 29.5 30.6 - MHz 40dB Bandwidth - 36.0 33.5 MHz Amplitude Ripple fo+/-13.5MHz - Relative Attenuation: Lower Sidelobe 40 48 - dB Upper Sidelobe 40 48 - dB Absolute Delay at Fo - 0.75 - us Group Delay Variation fo +/-13.5 MHz - 25 80 ns IN/OUT Return Loss at Fo - - - dB *With Matching Network (Ref. Testing Environment Circuit as Shown Below). Those impedances could be modified with different impedance values and/or structures, if necessary PACKAGE OUTLINE TEST CIRCUIT (mm) Oscilent Corporation IF SAW Filter | 813-SL125.0M-30 Page 2 of 2 TEST FIXTURE AND VALUES/SOURCE AND LOAD IMPEDANCE 50 ohm INPUT: L1: 100 nH; L2: 82 nH OUTPUT: L2: 68 nH; L4: 100 nH FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 813-SL125.0M-30