Oscilent Corporation IF SAW Filter | 813-SL70.0M-04 Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 813-SL70.0M-04 13.3 x 6.5 SMD IF SAW Filter Jan 01, 2007 TYPE : Low-Loss 70MHz IF SAW Filter PART NUMBER : 813-SL70.0M-04 OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 69.8 70.0 70.2 MHz Insertion Loss at Fo - 8.5 10.0 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Temperature Coefficient - -94 - ppm/C Amplitude Ripple within fo +/1.5MHz - 0.8 1.0 dBp-p 1dB Bandwidth - 3.68 - MHz 3dB Bandwidth - 4.46 - MHz 40dB Bandwidth - 7.18 - MHz Center Frequency (Fo) - Relative Attenuation: from 10 to 64.5MHz 40 45 - dB from 74 to 140MHz 40 43 - dB Absolute Delay at Fo - 1.0 - us IN/OUT Return Loss at Fo - - - dB Group Delay Variation/ fo +/-1.5MHz - 180 - us *With Matching Network (Ref. Testing Environment Circuit as Shown Below). Those impedances could be modified with different impedance values and/or structures, if necessary PACKAGE OUTLINE TEST CIRCUIT (mm) Oscilent Corporation IF SAW Filter | 813-SL70.0M-04 Page 2 of 2 TEST FIXTURE AND VALUES/SOURCE AND LOAD IMPEDANCE 50 ohm INPUT: L1:220 nH Q>40 OUTPUT: L2: 100 nH Q>40; C2: 22pF FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 813-SL70.0M-04