Oscilent Corporation IF SAW Filter | 813-SL70.0M-09 Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 813-SL70.0M-09 13.3 x 6.5mm Low-Loss IF SAW Filter Apr 18, 2007 . TYPE : 70.0 MHz SAW Filter Low-Loss 70MHz IF SAW Filter PART NUMBER : 813-SL70.0M-09 FREQUENCY RESPONSE OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units MHz 69.8 70.0 70.2 Insertion Loss at Fo - 10.7 11.5 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Bandwidth at -1.0 dB 8.4 8.66 - MHz Bandwidth at -3.0 dB 9.0 9.31 - MHz Bandwidth at -35.0 dB - 11.70 13.0 MHz - dB Center Frequency (Fo) - Relative Attenuation: from 10 to 64 MHz 40 46 from 77 to 140 MHz 40 42 - dB Amplitude Ripple within Fo +/- 3.7MHz - 0.60 1.0 dBp-p Group Delay Variation fo +/-3.7MHz - 125 160 nsec Absolute Delay at Fo - 0.94 - µsec Temperature Coefficient - -94 - ppm/°C *With Matching Network (Reference Testing Environment Circuit as shown) Modify Impedance Values as necessary. . Oscilent Corporation IF SAW Filter | 813-SL70.0M-09 PACKAGE OUTLINE Page 2 of 2 TEST FIXTURE (mm) L1 = 220nH C1 = 36pF L2 = 220nH C2 = 68pF Source/Load Impedance = 50 ohms PIN Descriptions: IN-11, OUT-5, GROUND-1,2,3,4,6,7,8,9,10,12 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 813-SL70.0M-09