Oscilent Corporation IF SAW Filter | 819-IF100.0M-C Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 819-IF100.0M-C 19 x 6.5 SMD Base Station, Repeater, HDR, IMT-2000 May 02 2003 . TYPE : 100.0 MHz Bandpass Filter 0.47 MHz Bandwidth PART NUMBER : 819-IF100.0M-C . Horizontal : 0.5 MHz/Div Veritical : 10 dB/Div Horizontal : 0.1 MHz/Div Veritical : 1 dB/Div Veritical : 100 ns/Div . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 99.97 100.0 100.03 MHz Insertion Loss - 13.7 15.0 dB 1dB Bandwidth 0.30 0.34 - MHz 3dB Bandwidth 0.47 0.55 - MHz 40dB Bandwidth - 1.38 1.40 MHz Passband Ripple - 0.8 1.5 dB Group Delay Variation - 250 500 nsec Center Frequency - 2.4 - µsec Ultimate Rejection 45 55 - dB Substrate Material - Quartz - - Ambient Temperature - 25 - °C Phase Linearity - 3.0 6.0 deg Absolute Delay * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE http://www.oscilent.com/spec_pages/if_sawfilter/if_819_if100_0c.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 819-IF100.0M-C Page 2 of 2 L1 = 162nH L2 = 132nH C1 = 18pF C2 = 39pF Source/Load Impedance = 50 ohms Part No.: 819-IF100.0M-C Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_819_if100_0c.htm 12/28/2005