IF SAW Filter Part Number Package Application Last Modified 820-IF75.0M-H 20.2 x 12.6mm Base Station & Repeater Apr 18, 2007 . TYPE : 75.0 MHz Bandpass Filter 19.55 MHz Bandwidth PART NUMBER : 820-IF75.0M-H .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency (Fo) - 75.0 - MHz Insertion Loss at Fo - 20.0 23.0 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Bandwidth at -1.0 dB - 19.15 - MHz Bandwidth at -3.0 dB - 19.55 - MHz Bandwidth at -40.0 dB - 21.40 - MHz Bandwidth at -50.0 dB - 21.55 - MHz Amplitude Ripple - 0.65 1.0 dBp-p Ultimate Rejection 55 60 - dB Group Delay Variation smo 0.5% - 61 - nsec Absolute Delay at Fo - 1.90 - µsec Temperature Coefficient - -72 - ppm/°C *With Matching Network (Reference Testing Environment Circuit as shown) Modify Impedance Values as necessary. . PACKAGE OUTLINE TEST FIXTURE (mm) L1 = 150nH C1 = 15pF L2 = 180nH C2 = 15pF Source/Load Impedance = 50 ohms PIN Descriptions IN-1, OUT-5, GROUND-2,3,4,6 FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 820-IF75.0M-H