IF SAW Filter Part Number Package Application Last Modified 820-IF120.0M-C 20.2 x 12.6mm IF SAW Filter Apr 18, 2007 . TYPE : 120.0 MHz IF SAW Filter PART NUMBER : 820-IF120.0M-C .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 119.94 120.0 120.06 MHz Insertion Loss at Fo - 22.2 24.0 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Bandwidth at -1.0 dB - 19.95 - MHz Bandwidth at -3.0 dB 20.25 20.35 - MHz Bandwidth at -35.0 dB - 21.70 - MHz Bandwidth at -40.0 dB - 21.80 22.0 MHz Amplitude Ripple - 0.75 1.0 dBp-p Ultimate Rejection 50 55 - dB Center Frequency (Fo) Group Delay Variation - 50 100 nsec Absolute Delay at Fo - 2.2 - µsec Temperature Coefficient - -72 - ppm/°C *With Matching Network (Reference Testing Environment Circuit as shown) Modify Impedance Values as necessary. . PACKAGE OUTLINE (mm) PIN Descriptions IN-1, Out-5, Ground-2,3,4,6 TESTING ENVIRONMENT Frequency Response Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 820-IF120.0M-C