Oscilent Corporation IF SAW Filter | 813-SL140.0M-05 Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 813-SL140.0M-05 13.3 x 6.5 SMD Base Station & Repeater Apr 18, 2007 . TYPE : 140.0 MHz Bandpass Filter Low Loss Narrow Bandwidth PART NUMBER : 813-SL140.0M-05 .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units MHz 139.85 140.0 140.15 Insertion Loss at Fo - 10.5 12.0 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Center Frequency Bandwidth at -1.0 dB 4.0 4.3 - MHz Bandwidth at -3.0 dB 4.8 5.08 - MHz Bandwidth at -40.0 dB - 7.7 7.9 MHz Bandwidth at -45.0 dB - 7.85 8.1 MHz - - - - Lower Sidelobe 45 50 - dB Upper Sidelobe Relative Attenuation: 45 50 - dB Amplitude Ripple - 0.3 1.0 dBp-p Group Delay Variation - 50 100 nsec Absolute Delay at Fo - 0.94 - µsec Temperature Coefficient - -94 - ppm/°C *With Matching Network (Reference Testing Environment Circuit as shown) Modifiy Impedance Values as necessary. . PACKAGE OUTLINE (mm) TEST FIXTURE Oscilent Corporation IF SAW Filter | 813-SL140.0M-05 Page 2 of 2 PIN Description: IN-11,OUT-5, GROUND-1,2,3,4,6,7,8,9,10,12 L1 = 47nH C1 = 43pF L2 = 47nH C2 = 43pF Source/Load Impedance = 50 ohms FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 813-SL140.0M-05