Oscilent Corporation IF SAW Filter | 824-IF70.0M-WA Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 824-IF70.0M-WA 24.7 x9.0 SMD 70.0 MHz IF SAW Filter Jan. 01, 2007 . TYPE : 70.0 MHz IF SAW Filter PART NUMBER : 824-IF70.0M-WA .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency (Fo) - 70.0 - MHz Insertion Loss - 8.5 12.0 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Temperature Coefficient - -0.03 - ppm/C Amplitude Ripple within fo+/-50.0Khz - 0.4 1.0 dBp-p 3dB Bandwidth 0.25 0.33 - MHz 50dB Bandwidth - 0.98 1.1 MHz from 10.0 to 69.2 MHz 50 57 - dB from 70.8 to 110.0 MHz 50 57 - dB Absolute Delay at Fo - 3.22 - µsec IN/OUT Return Loss at Fo - - - dB Relative Attenuation: *With Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedance values and/or structures, if necessary. ** Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE L1 = 200nH Q>40 C1 = 100pF L2 = 180nH Q>40 C2 = 51pF Source/Load Impedance = 50 ohms Pin Descriptions: IN-10, OUT-5, GROUND- 1,2,3,4,6,7,8,9 Oscilent Corporation IF SAW Filter | 824-IF70.0M-WA Page 2 of 2 FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 824-IF70.0M-WA