Oscilent Corporation IF SAW Filter | 835-IF32.7M-B Page 1 of 3 IF SAW Filter Part Number Package Application Last Modified 835-IF32.7M-B 35.0 x 12.8 Thru Hole Base Station & Repeater Jan. 01, 2007 . TYPE : 32.7 MHz Bandpass Filter PART NUMBER : 835-IF32.7M-B .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency (Fo) - 32.7 - MHz Insertion Loss at Fo - 27.5 30.0 dB Storage Temperature -40 - +85 °C Operating Temperature -40 - +85 °C Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Temperature Coefficient - -72 - ppm/°C Amplitude Ripple (29.7~ 35.7 MHz) - 0.55 1.0 dBp-p Phase Linearity (29.7~ 35.7 MHz) Bandwidth at 3.0 dB - 3.2 4.0 deg 6.6 7.05 - MHz - 7.97 8.3 MHz 50 55 - dB Group Delay Variation - 60 100 ns Adsolute Delay at Fo - 3.68 - us Bandwidth at 40.0 dB Ultimate Rejection * with Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedances values and/or structures, if necessary. ** Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) Oscilent Corporation IF SAW Filter | 835-IF32.7M-B Page 2 of 3 PIN Descriptions: IN-1, OUT 5, GROUND -2,3,4,6,Case TEST ENVIRONMENT Source & Load Impedance: 50 ohm FREQUENCY RESPONSE Part No.: 835-IF32.7M-B Oscilent Corporation IF SAW Filter | 835-IF32.7M-B Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map Page 3 of 3