OSCILENT 835-IF160.0M-J

Oscilent Corporation IF SAW Filter | 835-IF160.0M-J
Page 1 of 2
IF SAW Filter
Part Number
Package
Application
Last Modified
835-IF160.0M-J
35.0 x 12.8 Thru Hole
Base Station & Repeater
Jan. 01, 2007
TYPE :
160.0 MHz Bandpass Filter
PART NUMBER :
835-IF160.0M-J
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS
Minimum
Typical
Maximum
Units
159.9
160.0
160.1
MHz
Insertion Loss at Fo
-
28.0
30.0
dB
Storage Temperature
-40
-
+85
°C
Operating Temperature
-30
-
+70
°C
Source Impedance (single ended)*
-
50
-
ohm
Load Impedance (single ended)*
-
50
-
ohm
Temperature Coefficient
-
-20
-
ppm/°C
Center Frequency (Fo)
-
0.55
1.0
dBp-p
Bandwidth at 1.0 dB
8.95
9.15
-
MHz
Bandwidth at 3.0 dB
9.25
9.45
-
MHz
Bandwidth at 40.0 dB
-
10.55
10.8
MHz
Amplitude Ripple (Fo+/-4.375 MHz)
50
55
-
dB
Group Delay Variation (Fo+/-4.375
MHz)
-
40
100
ns
Adsolute Delay at Fo
-
3.45
-
us
Ultimate Rejection
* with Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with
different impedances values and/or structures, if necessary.
** Custom SAW IF Filters available. Contact Oscilent for assistance.
PACKAGE OUTLINE
(mm)
Oscilent Corporation IF SAW Filter | 835-IF160.0M-J
Page 2 of 2
PIN Descriptions: IN-1, OUT 5, GROUND -2,3,4,6,Case
TEST ENVIRONMENT
Source & Load Impedance: 50 ohm
FREQUENCY RESPONSE
Part No.:
Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map
835-IF160.0M-J