Oscilent Corporation RF SAW Filter | 862-RF2140.0M-A6 Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 862-RF2140.0M-A6 3.0 x 3.0 SMD WCDMA Jan. 01, 2007 . TYPE : WCDMA, RF-Rx SAW Filter PART NUMBER : 862-RF2140.0M-A6 .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss Stop Band Attenuation: Amplitude Ripple Source Impedence (single ended)* Condition Minimum Typical Maximum Units - - 2140.0 - MHz 2130.0~2150.0 MHz - 2.3 3.5 dB D.C.~500.0 MHz 21 35 - 500.0~ 1900.0 MHz 20 30 - 1900.0~ 2050.0 MHz 25 34 - 2070 MHz 38 42 - dB 2240.0~2300.0 MHz 25 38 2300.0~ 4500.0 MHz 20 28 - 2130.0~2150.0 MHz - 0.5 1.5 dBp-p - - 50 - ohm ohm - - 50 - 2130.0~2150.0 MHz - 1.7 2.3 - Maximum DC Voltage - - - 7.5 V Maximum Input Power - - - 15 dBm Operating Temperature - -5 - +70 ºC Load Impendance (single ended)* VSWR * No Matching Network (Ref. Testing Environment Circcuit as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground Oscilent Corporation RF SAW Filter | 862-RF2140.0M-A6 Load/ Source Impedance = 50ohms FREQUENCY RESPONSE Page 2 of 3 Oscilent Corporation RF SAW Filter | 862-RF2140.0M-A6 Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 862-RF2140.0M-A6