Oscilent Corporation RF SAW Filter | 805-RF325.3M-B Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 805-RF325.3M-B 5.0 x 5.0 SMD Wireless Jan. 01, 2007 . TYPE : Wireless RF SAW Filter PART NUMBER : 805-RF325.3M-B .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss Condition Minimum Typical Maximum Units - - 325.3 - MHz 322.0 ~ 328.6 MHz - 1.4 3.5 dB Fo-100.0 ~ Fo-39.5 MHz 45 55 - Fo+39.5 ~ Fo+100.0 MHz 45 55 - Source Impedence (single ended)* - - 200 - ohm Load Impendance (single ended)* - - 200 - ohm Attenuation: dB 322.0 ~ 328.6 MHz - 0.8 2.0 dB Maximum Input Power - - - 20 dBm Maximum DC Voltage - - - 5 V Operating Temperature - -40 - +85 ºC Amplitude Ripple * No Matching Network (Ref. Testing Environment Circuit as shown) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A In B Ground C In D Ground E Out F Ground G Out H Ground Oscilent Corporation RF SAW Filter | 805-RF325.3M-B Page 2 of 2 Source/ Load Impedance = 200 ohms FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 805-RF325.3M-B