Oscilent Corporation RF SAW Filter | 802-RF412.5M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 802-RF412.5M-A 3.0 x 3.0 SMD CDMA450 Jan. 01, 2007 . TYPE : CDMA450, RF-Tx SAW Filter PART NUMBER : 802-RF412.5M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Condition Minimum Typical Maximum Units - - 412.5 - MHz 410.0~415.0MHz - 2.5 3.2 dB 0.3~ 400.0 MHz 23 26 - 420.0~ 425.0 MHz 30 48 - 425.0~ 1700.0MHz 20 27 - 1700~ 2000.0 MHz 15 22 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm 410.0~ 415.0MHz - 1.3 2.0 - Maximum Input Power - - - 30 dBm Operating Temperature - -30 - +80 ºC Stop Band Attenuation: VSWR * No Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground dB Oscilent Corporation RF SAW Filter | 802-RF412.5M-A Source/Load Impedance = 50 ohms FREQUENCY RESPONSE Page 2 of 3 Oscilent Corporation RF SAW Filter | 802-RF412.5M-A Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF412.5M-A