155W Single Output with Battery Charger(UPS Function) AD-155 series Features : Universal AC input / Full range Protections: Short circuit / Overload / Over voltage Battery low and battery polarity protection Cooling by free air convection 100% full load burn-in test Fixed switching frequency at PFC 67KHz, PWM 134KHz 2 years warranty SPECIFICATION AD-155A MODEL OUTPUT INPUT AD-155B CH1 CH2 CH1 CH2 CH1 DC VOLTAGE 13.8V 13.3V 27.6V 27.1V 54V 53.5V RATED CURRENT 10.5A 0.5A 5A 0.5A 2.7A 0.2A CURRENT RANGE 0 ~ 11.5A 0 ~ 0.5A 0 ~ 5.5A 0 ~ 0.5A 0 ~ 2.7A 0 ~ 0.5A RATED POWER 151.55W 151.55W RIPPLE & NOISE (max.) Note.2 150mVp-p -------- 150mVp-p -------- CH1: 24 ~ 29V 1.0% VOLTAGE ADJ. RANGE CH1: 12 ~ 14.5V VOLTAGE TOLERANCE Note.3 2.0% 156.5W -------- 240mVp-p -------- -------- CH1: 48 ~ 58V 1.0% -------- 0.5% -------- 0.5% -------- 0.5% -------- LOAD REGULATION 0.5% -------- 0.5% -------- 0.5% -------- SETUP, RISE TIME 1000ms, 90ms/230VAC HOLD UP TIME (Typ.) 24ms/230VAC VOLTAGE RANGE 88 ~ 264VAC FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR (Typ.) PF>0.92 at full load EFFICIENCY (Typ.) 80% AC CURRENT (Typ.) INRUSH CURRENT (Typ.) 2.5A/115VAC OVERLOAD PROTECTION OVER VOLTAGE BATTERY LOW 2000ms, 90ms/115VAC at full load 20ms/115VAC at full load 124 ~ 370VDC 84% COLD START 20A/115VAC <1mA / 240VAC 40A/230VAC CH1:105 ~ 135% CH2:0.51 ~ 0.9A rated output power Protection type : AC Charging Mode : Constant current limiting, recovers automatically after fault condition is removed UPS Mode : Protected by internal fuse CH1:31.74 ~ 37.26V CH1:62.1 ~ 72.9V CH1:15.87 ~ 18.63V Protection type : Shut down o/p voltage, re-power on to recover 19.5V(+1.5V,-1V ) 10V 0.8V SAFETY STANDARDS SAFETY & WITHSTAND VOLTAGE ISOLATION RESISTANCE EMC (Note 4) EMC EMISSION UL60950-1, TUV EN60950-1 approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC DIMENSION PACKING 39V 2V (Refer to "Derating Curve") -10 ~ +60 EMC IMMUNITY MTBF 84% 1.5A/230VAC WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION NOTE CH2 LINE REGULATION LEAKAGE CURRENT OTHERS AD-155C OUTPUT NUMBER 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.03%/ (0 ~ 50 ) 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH Compliance to EN55022 (CISPR22) Class B, EN61000-3-2,-3 Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A 183.3K hrs min. MIL-HDBK-217F (25 199*110*50mm (L*W*H) 0.88Kg; 16pcs/15Kg/0.95CUFT ) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to EMI testing of component power supplies. (as available on http://www.meanwell.com) File Name:AD-155-SPEC 2011-06-16 155W Single Output with Battery Charger(UPS Function) AD-155 Mechanical Specification Case No. 906B series Unit:mm 192 5 172 3.5 12 6 100 1 9.5 2 3 97 110 4 8.2 5 6 5-M3 7 37 8 1 2 CN1 Terminal Pin No. Assignment 199 6 6.5 3.5 50 3M3 20 20 12 24.5 3.5 Pin No. 1 2 3 4 Assignment AC/L AC/N FG NC Pin No. 5 6 7 8 Assignment BAT. + BAT. -/COM DC OUTPUT COM DC OUTPUT +V CN1 Pin No. Assignment :JST B2B-XH or equivalent 25 16.5 190.5 Pin No. 1 2 Assignment Mating Housing RESET SW JST XHP or equivalent Terminal JST SXH-001T-P0.6 or equivalent 159 PFC fosc : 67KHz PWM fosc : 134KHz Block Diagram BAT.CHARGER BACK UP EMI FILTER & RECTIFIERS I/P PFC CIRCUIT O.L.P. ACTIVE START CIRCUIT RESET +V -V RECTIFIERS & FILTER POWER SWITCHING FG B+ CONSTANT CURRENT LIMITING & DETECTION CIRCUIT PWM & PFC CONTROL O.V.P. Derating Curve Output Derating VS Input Voltage (A) 100 100 +13.8V 90 With 21.6 CFM min.(10cm) 80 80 70 With NO FAN LOAD (%) LOAD (%) 60 40 20 -10 0 10 20 30 40 50 AMBIENT TEMPERATURE ( ) 60 70 (HORIZONTAL) 60 50 40 88 90 100 120 140 160 180 200 220 240 264 INPUT VOLTAGE (V) 60Hz File Name:AD-155-SPEC 2011-06-16