SUBMINIATURE SOLID STATE LAMP AM27SYC09 SUPER BRIGHT YELLOW Description Features The Super Bright Yellow devices is made with DH SUBMINIATURE PACKAGE. InGaAlP (on GaAs substrate) light emitting diode WIDE VIEWING ANGLE. chip. Z-BEND LEAD. LONG LIFE - SOLID STATE RELIABILITY. LOW PACKAGE PROFILE. PACKAGE :1000PCS / REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAD1334 REV NO: V.3 APPROVED: J. Lu CHECKED: Allen Liu DATE: APR/05/2005 DRAWN: W.J.ZHU PAGE: 1 OF 4 ERP:1202000409 Selection Guide Part No. Dice AM27SYC09 Iv (mcd) @ 20mA Lens Type SUPER BRIGHT YELLOW (InGaAIP) Viewing Angle Min. Typ. 2θ θ1/2 110 700 20° WATER CLEAR Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength Super Bright Yellow λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 590 nm IF=20mA Super Bright Yellow 588 nm IF=20mA Spectral Line Half-width Super Bright Yellow 28 nm IF=20mA C Capacitance Super Bright Yellow 25 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Yellow 2.0 2.5 V IF=20mA IR Reverse Current Super Bright Yellow 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Yellow Units Power dissipation 125 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1334 REV NO: V.3 APPROVED: J. Lu CHECKED: Allen Liu DATE: APR/05/2005 DRAWN: W.J.ZHU PAGE: 2 OF 4 ERP:1202000409 Super Bright Yellow AM27SYC09 SPEC NO: DSAD1334 REV NO: V.3 APPROVED: J. Lu CHECKED: Allen Liu DATE: APR/05/2005 DRAWN: W.J.ZHU PAGE: 3 OF 4 ERP:1202000409 AM27SYC09 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAD1334 REV NO: V.3 APPROVED: J. Lu CHECKED: Allen Liu DATE: APR/05/2005 DRAWN: W.J.ZHU PAGE: 4 OF 4 ERP:1202000409