ATMEL AT78C7005

Features
•
•
•
•
•
•
•
•
•
•
Operates from Single Supply: 3.3V or 5V
Small Footprint 64-Pin TQFP Package or Flip Chip
Precision Low-voltage Monitor Circuitry for the Power Supply
Master Power on Reset
Serial Port Interface with Read-back Capability
Over-temperature Protection/Warning
Shock Sensor Signal Processing
On-chip 1.8V, 2.5V and -3V Regulators
Low Power Consumption, 9 mA in Normal Run Mode
Spindle Driver
– Commutator is Driven by a FLL for High Immunity to Jitter
– Programmable 10-bit DAC
– Adjustable Slew Rate Control
– External Startup Capability
– 1.0A Current Capability with Ron = 1Ω
– Digital Commutation Delay and Blanking
– Programmable Delay from BEMF Zero Crossing
– External INDEX Signal for Spin Lock
– Active Spindle Braking Capability
• VCM Driver
– 0.4A Current Capability with Ron = 1.5Ω
– Programmable 14-bit DAC
– Ramp Load/Unload Capability with 10-bit ADC
– Power-off Retract with 9V Charge-pump
– Programmable VCM Current Controlled by Sense Resistor
• Available in a Variety of Packages Depending on Customer Requirements
Spindle/
VCM Motor
Controller/
Drivers
AT78C7005
Summary
Description
The AT78C7005 is a CMOS monolithic device that integrates Spindle and VCM controllers as well as power stages into one chip. The device operates from 3.3V or 5V
power supply. The AT78C7005 is designed for a small-form-factor hard disk drive
application.
A precision low-voltage detection circuit monitors the power supply and initiates VCM
retract at voltage fault condition. A 3-line serial port interface with read back capability
provides interface to the microprocessor.
The Spindle driver features a transconductance amplifier, a current sense amplifier,
power output drivers, sequencer, internal delay/masking logic, Spindle brake circuit,
FLL, and charge-pump for locking the spindle to the programmed rotational speed.
The VCM driver features a transconductance amplifier, differential input current sense
amplifier, ramp load/unload capability, and power output amplifier.
3432BS–NETST–5/04
Note: This is a summary document. A complete document
is available under NDA. For more information, please contact your local Atmel sales office.
ADVANCE
INDEX
BEMFO
SCOMP
Figure 1. AT78C7005 Block Diagram
MUX
VST
Prescaler
SYSCLK
CLK
Bemf
Comp
FLL
UP
DN
CHP
FLL
VSP
Comp
PWM
A
VSA
B
VSB
C
VSC
Voltage Limiter
SEQ
1
OTA
10 bit
DAC
VREF
VSN
Bemf
Comp
XIN
XOUT
3 bit
DAC
SHOCKIN
VREF
SDEN
Comp
SERIAL
PORT
F40
SCLK
SDATA
SHOCKB
VC1.8
V1.8
1.8V
VC2.5
V2.5
2.5V
OTSD
TMON
VC3.3
OTW
VVCC
3.3V
V3.3
VMP
VREF
BG
VREF
P
VCMP
N
VCMN
EA
IREF
RREF
RTH
VMN
POR
CRET
ERRO
PORB
ERRI
DRET
CRET
9V
PUMP
14 bit
DAC
M
U
X
10bit
ADC
BA
S/H
B
S/H
A
VCMS
SA
2
ISO
AVCC
AGND
DVCC
DGND
DACO
RVCC
RGND
RETO
AT78C7005
3432BS–NETST–5/04
AT78C7005
Packaging Information
64A1 – TQFP
PIN 1
B
PIN 1 IDENTIFIER
E1
e
E
D1
D
C
0˚~7˚
A1
A2
A
L
COMMON DIMENSIONS
(Unit of Measure = mm)
Notes:
1. This package conforms to JEDEC reference MS-026, Variation ACD.
2. Dimensions D1 and E1 do not include mold protrusion. Allowable
protrusion is 0.25 mm per side. Dimensions D1 and E1 are maximum
plastic body size dimensions including mold mismatch.
3. Lead coplanarity is 0.10 mm maximum.
SYMBOL
MIN
NOM
MAX
A
–
–
1.20
A1
0.05
–
0.15
A2
0.95
1.00
1.05
D
11.75
12.00
12.25
D1
9.90
10.00
10.10
E
11.75
12.00
12.25
E1
9.90
10.00
10.10
B
0.30
–
0.45
C
0.09
–
0.20
L
0.45
–
0.75
e
NOTE
Note 2
Note 2
0.50 TYP
4/22/2004
R
2325 Orchard Parkway
San Jose, CA 95131
TITLE
64A1, 64-lead, 10 x 10 mm Body Size, 1.0 mm Body Thickness,
0.5 mm Lead Pitch, Thin Profile Plastic Quad Flat Package (TQFP)
DRAWING NO.
64A1
REV.
A
3
3432BS–NETST–5/04
Atmel Corporation
2325 Orchard Parkway
San Jose, CA 95131, USA
Tel: 1(408) 441-0311
Fax: 1(408) 487-2600
Regional Headquarters
Europe
Atmel Sarl
Route des Arsenaux 41
Case Postale 80
CH-1705 Fribourg
Switzerland
Tel: (41) 26-426-5555
Fax: (41) 26-426-5500
Asia
Room 1219
Chinachem Golden Plaza
77 Mody Road Tsimshatsui
East Kowloon
Hong Kong
Tel: (852) 2721-9778
Fax: (852) 2722-1369
Japan
9F, Tonetsu Shinkawa Bldg.
1-24-8 Shinkawa
Chuo-ku, Tokyo 104-0033
Japan
Tel: (81) 3-3523-3551
Fax: (81) 3-3523-7581
Atmel Operations
Memory
2325 Orchard Parkway
San Jose, CA 95131, USA
Tel: 1(408) 441-0311
Fax: 1(408) 436-4314
RF/Automotive
Theresienstrasse 2
Postfach 3535
74025 Heilbronn, Germany
Tel: (49) 71-31-67-0
Fax: (49) 71-31-67-2340
Microcontrollers
2325 Orchard Parkway
San Jose, CA 95131, USA
Tel: 1(408) 441-0311
Fax: 1(408) 436-4314
La Chantrerie
BP 70602
44306 Nantes Cedex 3, France
Tel: (33) 2-40-18-18-18
Fax: (33) 2-40-18-19-60
ASIC/ASSP/Smart Cards
1150 East Cheyenne Mtn. Blvd.
Colorado Springs, CO 80906, USA
Tel: 1(719) 576-3300
Fax: 1(719) 540-1759
Biometrics/Imaging/Hi-Rel MPU/
High Speed Converters/RF Datacom
Avenue de Rochepleine
BP 123
38521 Saint-Egreve Cedex, France
Tel: (33) 4-76-58-30-00
Fax: (33) 4-76-58-34-80
Zone Industrielle
13106 Rousset Cedex, France
Tel: (33) 4-42-53-60-00
Fax: (33) 4-42-53-60-01
1150 East Cheyenne Mtn. Blvd.
Colorado Springs, CO 80906, USA
Tel: 1(719) 576-3300
Fax: 1(719) 540-1759
Scottish Enterprise Technology Park
Maxwell Building
East Kilbride G75 0QR, Scotland
Tel: (44) 1355-803-000
Fax: (44) 1355-242-743
Literature Requests
www.atmel.com/literature
Disclaimer: Atmel Corporation makes no warranty for the use of its products, other than those expressly contained in the Company’s standard
warranty which is detailed in Atmel’s Terms and Conditions located on the Company’s web site. The Company assumes no responsibility for any
errors which may appear in this document, reserves the right to change devices or specifications detailed herein at any time without notice, and
does not make any commitment to update the information contained herein. No licenses to patents or other intellectual property of Atmel are
granted by the Company in connection with the sale of Atmel products, expressly or by implication. Atmel’s products are not authorized for use
as critical components in life support devices or systems.
© Atmel Corporation 2004. All rights reserved. Atmel ® and combinations thereof, are the registered trademarks of Atmel Corporation or its
subsidiaries. Other terms and product names may be the trademarks of others.
Printed on recycled paper.
3432BS–NETST–5/04