Oscilent Corporation IF SAW Filter | 819-IF70.0M-RA Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 819-IF70.0M-RA 19 x 6.5 SMD Bandpass Filter Jan. 01, 2007 . TYPE : 70.0 MHz Bandpass Filter 1.26 MHz Bandwidth PART NUMBER : 819-IF70.0M-RA . FREQUENCY CHARACTERISTICS Horizontal : 0.5 MHz/Div Veritical : 10 dB/Div Horizontal : 0.2 MHz/Div Veritical : 1 dB/Div Veritical : 100 ns/Div . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 69.97 70.0 70.03 MHz Insertion Loss - 20.0 22.0 dB 1dB Bandwidth Center Frequency 1.26 1.30 - MHz Attenuation at Fo+/-1.25MHz 40 45 - MHz Attenuation at Fo+/-1.70MHz 40 45 - dB 40dB Bandwidth - 2.36 2.36 MHz Passband Ripple at Fo+/-0.5MHz - 0.8 1.0 dB Phase Linearity - 1.54 2.00 deg/rms Group Delay Variation - 250 500 nsec Absolute Delay - 2.6 - µsec Ultimate Rejection 40 50 - dB Substrate Material - Quartz - - Ambient Temperature - 25 - °C * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE Oscilent Corporation IF SAW Filter | 819-IF70.0M-RA Page 2 of 2 L1 =470nH L2 =470nH Source/Load Impedance = 50 ohms Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 819-IF70.0M-RA