Oscilent Corporation IF SAW Filter | 819-IF100.1M-A Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 819-IF100.1M-A 19 x 6.5 SMD Base Station, Repeater, HDR, IMT-2000 May 30 2003 . TYPE : 100.1 MHz Bandpass Filter 40.0 KHz Bandwidth PART NUMBER : 819-IF100.1M-A . Horizontal : 0.05 MHz/Div Veritical : 10 dB/Div Horizontal : 0.02 MHz/Div Veritical : 1 dB/Div . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency Minimum Typical Maximum Units - 100.1 - MHz Insertion Loss - 6.5 9.0 dB 1dB Bandwidth 30.0 34.0 - KHz 3dB Bandwidth 40.0 52.0 - KHz 40dB Bandwidth - 147.0 200.0 KHz Passband Ripple - 0.25 0.6 dB Group Delay Variation - 2.2 2.7 nsec - 17.8 - µsec Ultimate Rejection 50 60 - dB Substrate Material - Quartz - - Ambient Temperature - 25 - °C Absolute Delay * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE http://www.oscilent.com/spec_pages/if_sawfilter/if_819_if100_1a.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 819-IF100.1M-A Page 2 of 2 L1 = 82nH L2 = 87nH C1 = 91pF C2 = 36pF C3 = 82pF C4 = 32pF Source/Load Impedance = 50 ohms Part No.: 819-IF100.1M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_819_if100_1a.htm 12/28/2005