Oscilent Corporation IF SAW Filter | 819-IF150.0M-B Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 819-IF150.0M-B 19 x 6.5 SMD Base Station, Repeater, HDR, IMT-2000 May 02 2003 . TYPE : 150.0 MHz Bandpass Filter 1.50 MHz Bandwidth PART NUMBER : 819-IF150.0M-B . Horizontal : 1.0 MHz/Div Veritical : 10 dB/Div Horizontal : 0.2 MHz/Div Veritical : 1 dB/Div Veritical : 100 ns/Div . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 149.97 150.00 150.03 MHz Insertion Loss - 22.0 25.0 dB 1dB Bandwidth 1.26 1.31 - MHz 3dB Bandwidth 1.50 1.54 - MHz 30dB Bandwidth - 2.22 2.26 MHz Passband Ripple - 0.35 0.7 dB Group Delay Variation - 150 200 nsec Center Frequency - 2.45 - µsec Ultimate Rejection 40 50 - dB Substrate Material - Quartz - - Ambient Temperature - 25 - °C Phase Linearity - 2.0 5 degc Absolute Delay * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE http://www.oscilent.com/spec_pages/if_sawfilter/if_819_if150_0b.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 819-IF150.0M-B Page 2 of 2 L1 = 100nH L2 = 66nH C1 = 39pF C2 = 51pF R1 = 1Kohm R2 = 1Kohm Source/Load Impedance = 50 ohms Part No.: 819-IF150.0M-B Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_819_if150_0b.htm 12/28/2005