Oscilent Corporation IF SAW Filter | 820-IF76.9M-A Page 1 of 1 IF SAW Filter Part Number Package Application Last Modified 820-IF76.9M-A 20.2 x 12.6 Thru Hole Base Station & Repeater May 24 2003 . TYPE : 76.9 MHz Bandpass Filter 3.70 MHz Bandwidth PART NUMBER : 820-IF76.9M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 76.84 76.90 76.96 MHz Insertion Loss - 27.8 30.0 dB 3dB Bandwidth 3.70 3.85 - MHz 40dB Bandwidth - 5.30 5.50 MHz Passband Ripple - 0.40 1.0 dB Group Delay Variation - 60 100 nsec Ultimate Rejection - 50 - dB Substrate Material - LN - - Center Frequency * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE No Matching Required Source/Load Impedance = 50 ohms Part No.: 820-IF76.9M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_820_if76_9a.htm 12/28/2005