4.0x4.0mm RIGHT ANGLE SURFACE MOUNT LED LAMP AA4040YC Features YELLOW Description SINGLE COLOR. The Yellow source color devices are made with SUITABLE FOR ALL SMT ASSEMBLY AND Gallium Arsenide Phosphide on Gallium Phosphide SOLDER PROCESS. Yellow Light Emitting Diode. AVAILABLE ON TAPE AND REEL. IDEAL FOR BACKLIGHTING. PACKAGE : 500PCS / REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAA4909 REV NO: V.6 DATE: JUN/30/2005 PAGE: 1 OF 5 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP:1201000488 Selection Guide Part No. Dice AA4040YC Iv (mcd) @ 20 mA Lens Type YELLOW (GaAsP/GaP) WATER CLEAR Viewing Angle Min. Typ. 2θ θ1/2 4 9 90° Units Test Conditions Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. Max. λpeak Peak Wavelength Yellow 590 nm IF=20mA λD Dominant Wavelength Yellow 588 nm IF=20mA ∆λ1/2 Spectral Line Half-width Yellow 35 nm IF=20mA C Capacitance Yellow 20 pF VF=0V;f=1MHz VF Forward Voltage Yellow 2.1 2.5 V IF=20mA IR Reverse Current Yellow 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Yellow Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAA4909 REV NO: V.6 DATE: JUN/30/2005 PAGE: 2 OF 5 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP:1201000488 Yellow AA4040YC SPEC NO: DSAA4909 REV NO: V.6 DATE: JUN/30/2005 PAGE: 3 OF 5 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP:1201000488 AA4040YC Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) SPEC NO: DSAA4909 REV NO: V.6 DATE: JUN/30/2005 PAGE: 4 OF 5 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP:1201000488 PACKING & LABEL SPECIFICATIONS AA4040YC Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAA4909 REV NO: V.6 DATE: JUN/30/2005 PAGE: 5 OF 5 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP:1201000488