RADIO FREQUENCY IDENTIFICATION SYSTEMS Data Sheet HF Reader System Series 6000 S6350 Midrange Reader Module Specifications: Part Number RI-STU-TRDC-02 Operating Frequency 13.56 MHz ± 7 kHz Supported Transponders Tag-it HF, Tag-it HF-I & ISO 15693 compliant transponders Supply Voltage 5 VDC ± .5VDC Power Consumption 1250 mW Maximum Transmitter Power 120 mW into 50 Transmitter Modulation AM 10% - 30% (set at 20% nominal) or 100% - Software Selectable Data Coding Mode 1 / 4 or 1 / 256 Input/Output 16-pin Header Connector Antenna Connection 2 pins of 16-pin Header Connector Antenna Impedance 50 ± 5 Antenna Q, Loaded 10 < Q < 30 Communication Interface RS232 (via 16-pin Header Connector) Communication Parameters 57.6 K-baud, 8 data bits, 1 start bit, 1 stop bit & no parity Communication Protocol Tag-it & ISO Host protocol Memory Flash for downloadable firmware updates Synchronization Protocol synchronization via I/O Operating Temperature -20°C to +70°C Storage Temperature -40°C to +85°C Vibration Dimensions Weight (Typical) @ 13.56MHz 15 Hz to 500 Hz, 1g peak, 30 minutes sweep, logarithmic (MIL-STD-810E, Method 514.4) 4.3” x 2.7” x 0.4” 109.22mm x 68.58mm x 10.2mm (metric) 1.09 oz (31 grams) For more information, contact the sales office or distributor nearest you. This contact information can be found on our web site at: http://www.ti-rfid.com Texas Instruments reserves the right to change its products and services at any time without notice. TI provides customer assistance in various technical areas, but does not have full access to data concerning the uses and applications of customers products. Therefore, TI assumes no responsibility for customer product design or for infringement of patents and/or the rights of third parties, which may result from assistance provided by TI. © Copyright 2001 Texas Instruments Incorporated. Data Sh eet: 11-06-22-706 10/01