RADIO FREQUENCY IDENTIFICATION SYSTEMS Data Sheet HF Reader System Series 6000 S6550 Long Range Reader (Housed) Specifications: Part number RI-STU-655A Operating Frequency 13.56MHz ± 7kHz Supported Transponders Tag-it HF, Tag-it HF-I, ISO 15693 compliant Transponders Power Supply 100 - 120V / 60Hz or 220 - 240V / 50Hz switch selected Power consumption Max. 60W Transmitter power 0.5W to 10W ± 1dB (adjustable by software in 0.25W steps) above 4W output power an additional heat sink 0.8K/W is necessary Transmitter modulation AM (10% - 30%) ± 6% or 100% (adjustable by software) Antenna connection Basic antenna (TX/RX) Complementary antenna (RX only):: Antenna Impedance 50 Ohm at 13.56MHz Receive channels ASK 423.75kHz and FSK 423.75kHz / 484.29kHz for both antennas (adjustable by software) Communication Interfaces RS232 or RS485 (set by jumper) Address setting for interface Optional: - 3-position DIP switch (up to 8 addresses) - Software (up to 254 addresses) 1 x SMA female 1 x SMA female Communication Parameters Up to 115kBits, 8 data bits, even/odd/no parity Communication Protocol ISO Host Protocol Memory EEPROM 1kByte (for parameters; up to 10,000 write cycles) RAM 256 kByte (for data) Flash 512 kByte (for firmware; update via communication interface) Outputs 2 opto-coupled: 1 relay: 24V DC / 30mA 24V DC / 60W Inputs 2 opto-coupled: max. 24V DC / 20mA Synchronization Protocol synchronization via I/O Operating Temperature -20°C to +55°C Storage Temperature -25°C to +85°C Vibration EN60068-2-6 (10Hz to 200Hz: 0.15mm/2g) Casing Powder-coated sheet steel, look-up hinged lid Protection class IP54 Dimensions (L x W x H) 300mm x 200mm x 160mm Weight 5.5 kg For more information, contact the sales office or distributor nearest you. This contact information can be found on our web site at: http://www.ti-rfid.com Texas Instruments reserves the right to change its products and services at any time without notice. TI provides customer assistance in various technical areas, but does not have full access to data concerning the uses and applications of customers products. Therefore, TI assumes no responsibility for customer product design or for infringement of patents and/or the rights of third parties, which may result from assistance provided by TI. © Copyright 2001 Texas Instruments Incorporated. 11-06-22-100 07/01