RADIO FREQUENCY IDENTIFICATION SYSTEMS Data Sheet 32mm Glass Transponder Specifications: Part number RI-TRP-RR2B RI-TRP-WR2B RI-TRP-DR2B RI-TRP-IR2B Functionality Read Only Read/Write MPT SAMPT Memory (Bits) 64 80* 1360* 1360* Memory (Pages) 1 1 17*R/W 17*R/W*** Operating Frequency 134.2 kHz Modulation FSK (Frequency Shift Keying) 134.2 kHz / 123.2 kHz Transmission Principle HDX (Half Duplex) Power Source Powered from the reader signal (batteryless) Typical Reading Range ≤ 100 cm** Typical Programming Range --- Typical Read Time 70 ms Typical Programming Time --- 309 ms Typical Programming Cycles --- 100,000 30 % of specified reading range 86 ms 293 ms Operating Temperature (Read) -25 to +85°C Operating Temperature (Program) --- Storage Temperature -40 to +100°C (+125°C for total 1000 hours) Case Material Glass -25 to +70°C 341 ms -25 to +85°C Protection Class Hermetically sealed EMC Programmed code is not affected by normal electromagnetic interference or x-rays Signal Penetration Transponder can be read through virtually all non-metallic material Mechanical Shock IEC 68-2-27, Test Ea; 300 g, half sine, 3 ms, 2 axes Vibration IEC 68-2-6, Test Fc; 3 g, 5 - 50 Hz, 2 axes, 24 hours per axis 20 g, 10 - 2000 Hz, 2 axes, 2.5 hours per axis Dimensions ∅ 3.85 ± 0.05 mm * 31.2 ± 0.6 mm Weight 0.8 g ∅ 3.85 ± 0.05 mm * 32.2 ± 0.6 mm * We recommend that you split each 80 bit page into 64 user programmable bits plus a 16 bit wide CRC CCITT Block Check Character as is done by TI-RFID readers. ** Depending on RF regulation in country of use, the Reader Antenna configuration used, and the environmental conditions. *** 24 bits Selective Address width. For more information, contact the sales office or distributor nearest you. This contact information can be found on our web site at: http://www.ti-rfid.com Texas Instruments reserves the right to change its products and services at any time without notice. TI provides customer assistance in various technical areas, but does not have full access to data concerning the uses and applications of customers products. Therefore, TI assumes no responsibility for customer product design or for infringement of patents and/or the rights of third parties, which may result from assistance provided by TI. © Copyright 2001 Texas Instruments Incorporated. Data Sheet: 11-09-22-081 09/01