Image Reject Mixer / SSB Modulator Model IRM5xMS-1 RF 5.6 to 9.0 GHz Communications Band Electrical Specifications : (1) Conditions Specifications Parameter SSB Conversion loss:(2) (3) Image Rejection Sideband Suppression:(4) Isolation LO to RF: LO to I/Q: RF to I/Q: I/Q to RF: Input 1 dB Compression Point: RF(GHz) 5.6-9.0 LO(GHz) 5.6-9.0 IF(MHz) 50-90 Min Typical 5.0 dB 5.8-8.8 5.6-9.0 5.8-8.8 5.6-9.0 70 50-90 17 dB 16 dB 26 dB 23 dB 25 dB 25 dB 5.6-9.0 5.6-9.0 50-90 50-90 Input Third Order Intercept Point: 5.6-9.0 5.6-9.0 50-90 LO Power: 5.6-9.0 5.6-9.0 50-90 31 dB 40 dB 26 dB 40 dB +5 dBm +8 dBm +12 dBm +14 dBm +17 dBm +21 dBm +10 dBm +13 dBm +17 dBm (5) 5.6-9.0 5.6-9.0 5.6-9.0 Model IRM5xMS-1 Max 6.0 dB LO Power 4 = +10 dBm 6 = +13 dBm 7 = +17 dBm MIQ54 MIQ56 MIQ57 MIQ54 MIQ56 MIQ57 MIQ54 MIQ56 MIQ57 Notes: 1. Specifications are guaranteed when tested as a downconverter in a 50 Ohm system at +25˚C with the nominal LO power. Specifications indicated as typical are not guaranteed. 2. Noise Figure is typically within ±0.5 dB of conversion loss. 3. Conversion loss typically degrades less than 0.5 dB at +100˚C and improves less than 0.5 dB at -55˚C. 4. Measured with an IF quadrature hybrid whose amplitude and phase errors are 0.5 dB and 3 degrees maximum. 5. Usable LO drives are up to 2 dB below to 3 dB above nominal. 6. See Application notes M112, for aid in selecting the outline and for mounting and installation information. IRM5xMS-1 Outline: MSR7 Typical Performance at 25˚C 5.0 All dimensions are in inches and [mm]. Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, FL 32905 · PH (888) 553-7531 · Fax (888) 553-7532 www.SpectrumMicrowave.com Spectrum Microwave (Europe) · 2707 Black Lake Place · Philadelphia, PA 19154 · PH (215) 464-4000 · Fax (215) 464-4001