Model MC5xMS-7 Model MC5xMS-15 Double Balanced Mixer Communications Band RF 3.5 to 15.0 GHz Electrical Specifications: (1) Specifications Conditions Parameter SSB Conversion loss:(2) (3) Isolation LO to RF: LO to IF: RF to IF: IF to RF: RF(GHz) 3.7-14.5 3.7-14.5 3.5-15.0 LO(GHz) 3.7-14.5 3.7-14.5 3.5-15.0 IF(MHz) DC-500 DC-2000 DC-4000 27 dB 23 dB 3.5-15.0 3.5-15.0 3.5-15.0 DC-2000 DC-4000 Input 1-dB Compression Point: 3.5-15.0 3.5-15.0 DC-4000 Input Third Order Intercept Point: 3.5-15.0 3.5-15.0 DC-4000 LO Power: 3.5-15.0 3.5-15.0 DC-4000 (4) Min Typical 5.0 dB 5.5 dB 7.5 dB 35 dB 38 dB 23 dB 20 dBm 14 dBm +1 dBm +4 dBm +8 dBm +12 dBm +11 dBm +14 dBm +18 dBm +22 dBm +7 dBm +10 dBm +13 dBm +18 dBm Notes: 1. Specifications are guaranteed when tested as a downconverter in a 50 Ohm system at +25˚C with the nominal LO power. Specifications indicated as typical are not guaranteed. 2. Noise figure is typically within ±0.5 dB of conversion loss if IF frequencies greater than 10 MHz. 3. Conversion loss typically degrades less than 0.5 dB at +100˚C and improves less than 0.5 dB at -55˚C. 4. Usable LO drives are up to 2 dB below and 3 dB above nominal. 5. See Application note M112, for aid in selecting the outline and for mounting and installation information. MC5xMS-7 MC5xMS-15 NOTE: (UNLESS OTHERWISE SPECIFIED) 1. LO, RF, AND IF TRACES ARE .020” WIDE SOLDER COATED OR PLATED COPPER SUITABLE FOR SOLDER ATTACH. Max 7.0 dB 7.5 dB 9.5 dB Model MC5xMS-7 Model MC5xMS-15 Outline: MS3C LO Power 3 = +7 dBm 4 = +10 dBm 6 = +14 dBm 7 = +18 dBm MC53 MC54 MC56 MC57 MC53 MC54 MC56 MC57 MC53 MC54 MC56 MC57 Typical Performance at 25˚C Outline: MS3D All dimensions are in inches and [mm]. Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, FL 32905 · PH (888) 553-7531 · Fax (888) 553-7532 www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, PA 19154 · PH (215) 464-4000 · Fax (215) 464-4001 REV A 4/25/11