THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS CW 0701 FPLD62T2 100.0M SURFACE MOUNT 3.3V LVPECL CLOCK FPLD62T2 ABSOLUTE MAXIMUM RATINGS TABLE 1.0 PARAMETER UNITS MINIMUM NOMINAL MAXIMUM UNITS -40 - 85 °C -0.5 - 7.0 Vdc Storage Temperature Supply Voltage (Vcc) OPERATING SPECIFICATIONS NOTE TABLE 2.0 PARAMETER MINIMUM NOMINAL MAXIMUM UNITS NOTE 16 -50 -40 - MHz ppm °C 1 - 250 50 85 (Vcc) 3.135 3.3 3.465 Vdc (Icc) - - 60 mA Jitter (BW=10Hz to 20MHz) - - 5 pS RMS Jitter (BW=12kHz to 20MHz) - - 1 pS RMS Start Up Time - - 10 mS MINIMUM 2.275 45 - NOMINAL 50 - MAXIMUM 50 1.68 55 1 UNITS Ohms Vdc Vdc % nS Center Frequency Total Frequency Tolerance Operating Temperature Range (Fo) Supply Voltage Supply Current PECL OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) Duty Cycle Rise / Fall Time 20% to 80% DESCRIPTION The Connor-Winfield FPLD62T2 is a fixed frequency, surface mount Crystal Controlled Oscillator (XO) designed for applications requiring low jitter and a ±50ppm overall stability. Operating at 3.3V supply voltage, the FPLD62T2 provides LVPECL Differential Outputs. TABLE 3.0 (Voh) (Vol) NOTE 2 FEATURES 3 3.3V OPERATION LVPECL DIFFERENTIAL OUTPUTS PACKAGE CHARACTERISTICS Package TABLE 4.0 Non-hermetic package consisting of an FR4 subs trate with grounded metal cover. LOW JITTER <1pS RMS OVERALL FREQUENCY TOLERANCE ±50ppm PROCESS RECOMMENDATIONS Solder Reflow TABLE 5.0 The component solder to used internal to thistemperature device hasofaless m elting point of to This componet is designed withstand a peak than or equal 221°C. The peak temperature inside the device should be less t han or equal 235°C for a maximum of 10 seconds. to 220°C for a maximum of 10 seconds Ultrasonic cleaning is not recommended. Wash TEMPERATURE RANGE: -40 to 85°C SURFACE MOUNT PACKAGE Notes 1) Includes initial tolerance, deviation over temperature, supply and load variations, shock, vibration and 20 years aging. 2) Output must be terminated into 50 ohms to Vcc – 2V or Thevenin equivalent. 3) Duty Cycle measured at 1.977V TAPE AND REEL PACKAGING ORDERING INFORMATION FPLD62T2 - 100.0MHz LV PECL CLOCK SERIES CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Ec177 PAGE 1 OF 2 01 REV: 00 DATE: 1/21/03 1/24/03 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CW FPLD62T2 100.0M CRYSTAL CONTROLLED OSCILLATORS 2 3 1 4 Q OUTPUT GROUND Q OUTPUT Vcc Dimensional Tolerance: ±.005” (.127mm) 80% 50% 20% 2 Specifications subject to change without notice. DATA SHEET #: Ec177 PAGE 2 OF 2 00 REV: 01 1/21/03 DATE: 1/24/03 aCopyright 2001 Connor-Winfield all rights reserved.