SHIELDED SMD POWER INDUCTOR Industries P177032C SERIES • Low profile package • Low DC resistance • High current handling capacity • Operating temperature range: -40oC to +85oC • Storage temperature range: -40oC to +85oC • RoHS compliant product ELECTRICAL SPECIFICATION @ 20OC Part Number P177032C- Inductance (µH) (±20%) DC Resistance (mΩ) (±20%) Rated DC Current (A) (Max) 3R3M 3.30 23 1.90 4R7M 4.70 36 1.70 6R8M 6.80 41 1.60 100M 10.00 53 1.40 150M 15.00 75 1.10 220M 22.00 110 0.96 330M 33.00 160 0.75 470M 47.00 240 0.67 680M 68.00 310 0.59 101M 100.00 450 0.45 151M 150.00 650 0.37 221M 220.00 1050 0.29 331M 330.00 1670 0.22 471M 470.00 2050 0.20 681M 680.00 3150 0.16 102M 1000.00 4780 0.13 • Inductance measured at 100kHz / 0.5V • Inductance drop 20% Typical at Idc from initial value • Temperature rise 40 °C Typcial at Idc from 20 °C Product performance is limited to specified parameters. Data is subject to change without prior notice. 13200 Estrella Ave., Bldg. B Gardena, CA 90248 Tel: 310-325-1043 Fax: 310-325-1044 Dimensions Unless otherwise specified, all tolerances are: inch: .XX : ±0.015 .XXX : ±0.004 mm: X,X : ±0,38 X,XX : ±0,10 www.mpsind.com [email protected] SHIELDED SMD POWER INDUCTOR Industries P177032C SERIES DIMENSIONS EPOXY 6R8 A = 7.0 ± 0.2 mm B = 7.0 ± 0.2 mm C = 3.4 max mm D = 6.8 ± 0.3 mm E = 4.5 ref mm F = 2.0 ref mm G = 1.0 ref mm INDUCTANCE CURVE VS. CURRENT (6.8 μH sample reading) INDUCTANCE CURVE VS.CURRENT 8.00 INDUCTANCE(uH) 7.00 6.00 5.00 4.00 3.00 2.00 1.00 0.00 0A 0.45A 0.9A 1.35A 1.6A 2.25A 2.7A DC CURRENT(A) TEMPERATURE CURVE VS. CURRENT (6.8 μH sample reading) TEMPER TURE RISE CURVE VS.CURRENT TEMPERATURE RISE(℃) 45.00 40.00 35.00 30.00 25.00 20.00 15.00 10.00 5.00 0.00 0A 0.55A 1.1A 1.6A 2.2A 2.75A 3.3A DC CURRENT(A) Product performance is limited to specified parameters. Data is subject to change without prior notice. 13200 Estrella Ave., Bldg. B Gardena, CA 90248 Tel: 310-325-1043 Fax: 310-325-1044 Dimensions Unless otherwise specified, all tolerances are: inch: .XX : ±0.015 .XXX : ±0.004 mm: X,X : ±0,38 X,XX : ±0,10 www.mpsind.com [email protected]