PolySwitch® PTC Devices 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 www.circuitprotection.com PRODUCT: Overcurrent Protection Device Raychem Circuit Protection Products AHRF650 DOCUMENT: SCD 25185 PCN: A43987 REV LETTER: B REV DATE: MAY 8, 2007 PAGE NO.: 1 OF 2 Specification Status: RELEASED Electrical Rating Voltage: 16VDC MAX Insulating Material: Cured, Flame Retardant Epoxy Polymer Lead Material: 20 AWG Tin Plated Copper (0.8 mm [0.032] nom. diameter) Part Marking: Raychem Logo and Voltage 16 HF6.5 Part Identification Lot Identification (can be on back) TABLE I. INSTALLATION ENVELOPE DIMENSIONS: mm: in*: A B MIN MAX MIN MAX -12.7 -22.2 -(0.50) -(0.88) *Rounded off approximation C MIN 4.3 (0.17) D MAX 5.8 (0.23) MIN 7.6 (0.30) E MAX --- MIN --- MAX 3.0 (0.12) F TYP 1.2 (0.05) G MIN --- MAX 5.08 (0.20) TABLE II. PERFORMANCE RATINGS: CURRENT RATINGS TIME TO TRIP AMPS SECONDS AT AT 25°C 25°C, 32.5 A HOLD TRIP MAX 6.5 13.7 7.0 Reference Documents: Precedence: Effectivity: CAUTION: RESISTANCE Ra MAX OHMS AT 25°C MIN MAX 0.009 0.018 OHMS AT 25°C 0.026 TRIPPED-STATE POWER DISSIPATION WATTS AT 25°C TYP 4.3 PS400, PS300 (reference for R1 MAX) This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame. © 2002, 2007 Tyco Electronics Corporation. All rights reserved. PolySwitch® PTC Devices 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 www.circuitprotection.com Overcurrent Protection Device Raychem Circuit Protection Products PRODUCT: AHRF650 DOCUMENT: SCD 25185 PCN: A43987 REV LETTER: B REV DATE: MAY 8, 2007 PAGE NO.: 2 OF 2 TABLE III. AUTOMOTIVE SPECIFIC STRESS TESTS AND TEST CONDITIONS: ELECTRICAL STRESS TESTS TEST CONDITIONS (see note 2) ESD Voltage Withstand (see note 1) Short Circuit Fault Current Durability 25kV Fault Current Durability 350 cycles, 16V/100A End-of-life Mode Verification 1750 cycles, 16V/100A Jump Start Endurance (see note 1) Load Dump Endurance (see note 1) 3 cycles, 26V, 1 minute duration 25 cycles, 16V, 200A 10 cycles, 86.5V Note 1: The PolySwitch devices are tested in series with a load resistance and the voltages specified in the test conditions are shared between the PolySwitch device and the load resistance as specified in PS400. Note 2: Please refer to Appendix A of PS400 for the detailed test procedures