PRODUCT: TS600-200-RA-B-0.5 PolySwitch® PTC Devices 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 www.circuitprotection.com Overcurrent Protection Device Raychem Circuit Protection Products DOCUMENT: SCD 24211 PCN: 045845, C02530 REV LETTER: J REV DATE: MAY 8, 2007 PAGE NO.: 1 OF 1 Specification Status: RELEASED Max Electrical Rating at 20°C Operating Voltage: 60VDC Interrupt Current: 3ARMS Fault Voltage: 600VRMS Terminal Material: Tin plated brass Case Material: 1000 V Dielectric rating Marking: Raychem Logo T20 Part Identification Lot Identification TABLE I. DIMENSIONS: mm: in*: A B MIN MAX MIN MAX 18.29 19.43 11.56 12.32 (0.720) (0.765) (0.455) (0.485) *Rounded off approximation C MIN 7.24 (0.285) D MAX 8.26 (0.325) MIN 1.65 (0.065) E MAX 2.41 (0.095) MIN 9.91 (0.390) F MAX 10.41 (0.410) MIN 1.52 (0.060) MAX 2.29 (0.090) TABLE II. PERFORMANCE RATINGS @ 20°C (unless otherwise noted): IHOLD (A) 20°C 0.200 70°C 0.110 RESISTANCE (Ω) R MIN 4.0 R MAX 7.5 R1Inst* 13.5 TIME TO TRIP(s) OPERATING @ 1A Temperature (°C) R1 MAX** TYP MIN MAX 13.5 12 -40 85 Power Dissipation Watts, Typical 2.5 *Post Reflow Resistance, measured after one hour. **Maximum device resistance at 20°C measured 1 hour post trip. Resistance Matched Agency Recognition: Reference Documents: Precedence: Effectivity: CAUTION: 0.5 Ohm CSA, UL Recognition file #E74889 PS300 This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame. © 2006, 2007 Tyco Electronics Corporation. All rights reserved.